Samsung AP55M2ANUMG, AF55GC1MBEENMG, AP55M0AXUMG, AP55M1ANUMG, AF55GC1MAEENMG manual Basic operation

Page 13

Basic operation

Basic operation is an operation mode that can be selected by pressing the Mode button.

Auto

In Auto mode, the air conditioner will automatically set the Operation(Cool/Heat Mode) and fan speed depending on the room temperature detected by the room temperature sensor. (Heat mode is applicable to AP55M1✴, AF55GP1M✴ model only.)

Cool

Cool mode is frequently used and you can freely control the temperature, fan speed, and air flow direction in cool mode.

Dry

The air conditioner in Dry mode acts like a dehumidifier by removing moisture from the indoor air. The Dry mode will provide you with fresh air even on a rainy day.

ffOutdoor unit will repeatedly and automatically turn on/off for maximum dehumidification according to the temperature difference of the current and desired temperature.

Fan

Fan mode can be selected to ventilate your room. Fan mode will be helpful to refresh the stale air in your room.

fIfyou are not going to use the air conditioner for a while, we recommend to operate the Fan mode for 3~4 hours to dry the internal part of the air conditioner..

Heat (Applicable model: AP55M1✴, AF55GP1M✴)

In Heat mode, the indoor temperature, fan speed, and air flow direction can be adjusted at your desire to warm your indoor.

ffIndoor unit may not start the operation immediately until indoor heat exchanger is warmed up to a certain temperature (approximately 5 minutes according to current indoor temperature) to prevent generating a cold breeze.

ffDefrost display: When removing frost at the outdoor unit in the Heat mode, (Defrost) icon will be displayed on the indoor unit display and it will be turned off after removing the frost.

(When removing the frost during the defrost operation in Heat mode, steam may be generated and the warm breeze may not come out from the indoor unit.)

• When the outdoor temperature is low and humidity is high, frost may form on outdoor unit's heat exchanger

NOTE

and may decrease the heating performance so the Defrost operation will operate for 5 ~ 12 minutes to get rid of

the frost on the outdoor unit heat exchanger. Indoor unit will be off during Defrost operation is on since cold air

 

 

may come out from it.

 

-- Intervals between Defrost operation cycle may vary depending on the amount of frost on the outdoor unit.

 

-- In snowy or rainy days, Defrost operation cycle may be shorter due to humidity.

 

-- You cannot control the air conditioner with the remote controller while Defrost operation is on. Try to control

 

the air conditioner after Defrost operation is complete.

14

PAC MIRAGE HPCO-AR-PH_IBIM_05321A-01_EN.indd 14

2015-03-03 오후 4:39:33

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Strong Turbo/Long Function Features of your new air conditionerLook for Everywhere Contents Important safety symbols and precautions Safety precautionsDo not yank the power cable with hands Severe Warning Signs FfPotential risk of injury or electric shock Use a rated circuit breaker onlyFfPotential risk of personal injury Do not open the front panel during operationFfInsufficient ventilation may result in poor performance Do not allow children to climb on the air conditionerFfPotential risk of personal injury or property loss FfWearing thick gloves can protect your hands Checking the indoor unit and display Checking the name of the partsMain parts To open the panelHeater and Purity functions are not supported by this model Control panelRemote controller buttons Checking the remote controllerUsing the remote controller Remote controller displayLamps are in the same space Storing the remote controller Battery changing timeInserting the batteries Indoor unitBasic operation Selecting the operation mode Turning on the powerAdjusting the desired temperature Selecting the fan speedSelecting air flow direction When the air conditioner is off Setting the On/Off timerYou cannot set the fan speed when setting the On timer Additional options available in On timerBe different from each other When the air conditioner is onUsing the Long function Using the Turbo functionWhen the air conditioner is operating in Cool or Heat mode Locking the control panel FfYou can increase/decrease the temperature by 1 C Button to adjust the temperatureButton to adjust the fan speed Cleaning the exterior Cleaning and maintaining the air conditionerCleaning the filter Air filter Periodical checks Maintaining your air conditionerType Description Internal protections via the unit control system Have deposited at low temperaturesOutdoor unit after it has been started Appendix TroubleshootingHumidity Operation rangesAccessing its internal components Installing the unitGeneral information Do not install the air conditioner in following places Power supply line, fuse or circuit breakerMake sure that you earth the cables Complete, electric shock or fire may occurPart Name Accessory parts listIndoor unit Selection of installation placeTop view Side viewOutdoor unit Selecting appropriate location for installation Preparing the installationUnit for exhausted air to ventilate Wear protective goggles and mask before spraying Space requirementsElectrical work Wiring standardCord. Code designation IEC60245 IEC 66 / CENELECH07RN-F Using 3poles ELCBEarth Leakage Circuit Breaker Indoor and outdoor connection wiringAP55M0 Series AP55M1 SeriesUsing 3poles Elcb and 2poles Elcb Using 4poles ELCBEarth Leakage Circuit BreakerAP55M2 Series AF55GC1M Series Using 2poles ELCBEarth Leakage Circuit BreakerAF55GP1M Series Connecting the power terminal Electrical wiringScrew Tightening torque kgf·cm Outdoor unit When using the anchor bolt Installation methodWhen using the rubber leg Put the rubber leg to the outdoor unit legInstallation procedures When Wiring Refrigerant pipe work Insulating the pipes Check the following list and install an oil trapOil trap FfHeight of the oil trap H 4R ≤ H ≤ 6RConnection of refrigerant piping Flare processing Cut the pipe using the pipe cutterRemove burr on the edge of pipe It may cause explosion and injuryTightening of connection parts Pipe bendingDrilling a hole in the wall Outer diameter mm Tightening torque kgf·cmDrain hose Wall installation Corner InstallationFixing the indoor unit ExampleBe sure that all valve cocks are closed Air purgePressure table for temperatures How to add refrigerantRefrigerant charging AP55M0AN AF55GC1M N AF55GP1M N FfCooling operationsCheck Check and test operationIs grounding properly made? When the outdoor temperature is below zero, do not Pump down procedure When removing the productTest operation Packing and unpacking guide Outdoor unit To finish How to connect your extended power cablesModel Product specificationQuestions or COMMENTS? Thank you for purchasing this Samsung product Air Conditioner
Related manuals
Manual 54 pages 8.23 Kb

AP55M0ANUMG, AF55GP1MBEENMG, AP55M2ANUMG, AF55GC1MBEENMG, AF55GC1MAEENMG specifications

Samsung has established a reputation for innovation in the realm of technology, particularly with its display solutions. Among its latest offerings in the market are the AP55M0AXUMG, AP55M0BNUMG, AP55M1ANUMG, AF55GC1MAEENMG, and AF55GC1MBEENMG models. These displays cater to various commercial applications, boasting impressive specifications and cutting-edge technologies that enhance user experiences.

The AP55M0AXUMG and AP55M0BNUMG are part of Samsung's premium range, featuring a stunning 55-inch display that utilizes advanced LED technology for vibrant colors and remarkable clarity. Both models support 4K resolution, ensuring that images are sharp and lifelike, which is particularly beneficial for presentations, advertising, and other commercial uses. With an ultra-narrow bezel, these displays maximize the viewing area while maintaining a sleek profile that seamlessly blends into any environment.

Equipped with powerful processors, these displays support seamless multitasking capabilities and real-time content sharing. Their compatibility with various content management systems allows users to create dynamic displays for effective engagement with their audience. The built-in Wi-Fi capabilities ensure easy connectivity, making it simple for users to update content remotely.

The AP55M1ANUMG model takes things a step further by incorporating Samsung's MagicINFO solution, which enables users to manage, schedule, and control multiple screens from a single interface. This feature is particularly advantageous for businesses that require coordinated messaging across multiple locations. Additionally, this model boasts enhanced brightness and contrast ratios, ensuring visibility even in well-lit environments.

On the other hand, the AF55GC1MAEENMG and AF55GC1MBEENMG displays cater to those seeking high-quality performance along with advanced interactive capabilities. Both models employ Samsung's innovative touch technology, allowing users to interact directly with the content displayed. This makes them ideal for educational and collaborative settings, where engagement and interactivity are paramount.

Furthermore, these displays are designed with durability in mind, featuring a robust construction that can withstand various environmental conditions. The energy-efficient design ensures lower operational costs, making them a sustainable choice for businesses looking to reduce their carbon footprint while still delivering high-impact visual experiences.

In conclusion, Samsung's AP55M0AXUMG, AP55M0BNUMG, AP55M1ANUMG, AF55GC1MAEENMG, and AF55GC1MBEENMG models are at the forefront of display technology, providing businesses and educational institutions with the tools they need to communicate effectively and capture audience attention. Their advanced features, combined with Samsung's legacy of quality, make these displays a sagacious investment for any organization seeking to elevate its digital presentation capabilities.
Top Page Image Contents