Samsung AP55M0AXUMG manual Refrigerant pipe work Insulating the pipes, Oil trap, Pipe diameter D

Page 41

Installation method

Refrigerant pipe work

Insulating the pipes

ffMake sure to insulated the refrigerant pipes with an insulation tape. If the pipe is not insulated, condensate may form and drop into the indoor.

ffWind the refrigerant pipes and the drain hose with vinyl tapes.

ffWhen you bend the pipe, try to secure large bending radius (over 100 mm) to prevent the copper pipe from distorting.

ffUse foamed polyethylene or EPDM foam, with thickness over 7 mm, as an insulator.

fIfthe pipe is installed in a place with humidity over 80 % (such as within a pit of a building, basement, sea shore, near hot spring or lake etc), use an insulator with a thickness over 10 mm.

Pipe insulator

 

Vinyl

Indoor/

tape

 

outdoor unit

 

communication

 

cable

 

 

Drain hose

ffInsulate the high pressure (liquid pipe)/low pressure (gas pipe) pipe, and finish it by winding up the vinyl tape around it.

ffMake sure to insulate the pipe with no gap or cracks, and use adhesive between the connection part of the insulator to prevent moisture from entering.

ffMake sure that the thickness of the insulator doesn’t get thinner on the bending part of the pipes. ffUse extra insulator to secure thickness when the insulator becomes thinner.

ffWhen the pipe hanger is installed, wind the extra PE Foam type insulator (over 5 mm) with the width 3 times wider than the hanger. (Do not use cable tie as an hanger.)

Oil trap

Check the following list and install an oil trap.

ffInstall an oil trap only when the outdoor unit is at a higher level than the indoor unit. ffBased on cooling operation, install it on the gas side pipe only.

ffInstall the oil trap only in between the outdoor unit and the first branch joint and it should be installed at every 10 m. ffRadius of curvature (R) on the oil trap are as follows:

 

(Unit: mm)

 

 

Pipe diameter (D)

Radius of curvature (R)

12.70

25 and over

15.88

32 and over

 

 

19.05

38 and over

 

 

22.23

41 and over

 

 

25.40

51 and over

 

 

28.60

57 and over

 

 

31.75

60 and over

ffHeight of the oil trap (H): 4R ≤ H ≤ 6R

Outdoor unit

Oil trap

 

(Gas side pipe: Install

Insulation

it at every 10 m)

 

Branch joint

Cut on insulation

 

Indoor unit

42

PAC MIRAGE HPCO-AR-PH_IBIM_05321A-01_EN.indd 42

2015-03-03 오후 4:39:46

Page 40 Page 42
Image 41
Page 40 Page 42
Contents Look for Everywhere Features of your new air conditionerStrong Turbo/Long Function Contents Do not yank the power cable with hands Safety precautionsImportant safety symbols and precautions Severe Warning Signs FfPotential risk of injury or electric shock Use a rated circuit breaker onlyFfPotential risk of personal injury Do not open the front panel during operationFfPotential risk of personal injury or property loss Do not allow children to climb on the air conditionerFfInsufficient ventilation may result in poor performance FfWearing thick gloves can protect your hands Checking the indoor unit and display Checking the name of the partsMain parts To open the panelHeater and Purity functions are not supported by this model Control panelRemote controller buttons Checking the remote controllerLamps are in the same space Remote controller displayUsing the remote controller Storing the remote controller Battery changing timeInserting the batteries Indoor unitBasic operation Selecting the operation mode Turning on the powerAdjusting the desired temperature Selecting the fan speedSelecting air flow direction When the air conditioner is off Setting the On/Off timerYou cannot set the fan speed when setting the On timer Additional options available in On timerBe different from each other When the air conditioner is onWhen the air conditioner is operating in Cool or Heat mode Using the Turbo functionUsing the Long function Locking the control panel Button to adjust the fan speed Button to adjust the temperatureFfYou can increase/decrease the temperature by 1 C Cleaning the filter Air filter Cleaning and maintaining the air conditionerCleaning the exterior Type Description Maintaining your air conditionerPeriodical checks Outdoor unit after it has been started Have deposited at low temperaturesInternal protections via the unit control system Appendix TroubleshootingHumidity Operation rangesGeneral information Installing the unitAccessing its internal components Do not install the air conditioner in following places Power supply line, fuse or circuit breakerMake sure that you earth the cables Complete, electric shock or fire may occurPart Name Accessory parts listIndoor unit Selection of installation placeTop view Side viewOutdoor unit Unit for exhausted air to ventilate Preparing the installationSelecting appropriate location for installation Wear protective goggles and mask before spraying Space requirementsCord. Code designation IEC60245 IEC 66 / CENELECH07RN-F Wiring standardElectrical work Using 3poles ELCBEarth Leakage Circuit Breaker Indoor and outdoor connection wiringAP55M0 Series AP55M1 SeriesAP55M2 Series Using 4poles ELCBEarth Leakage Circuit BreakerUsing 3poles Elcb and 2poles Elcb AF55GP1M Series Using 2poles ELCBEarth Leakage Circuit BreakerAF55GC1M Series Screw Tightening torque kgf·cm Electrical wiringConnecting the power terminal Outdoor unit When using the anchor bolt Installation methodWhen using the rubber leg Put the rubber leg to the outdoor unit legInstallation procedures When Wiring Refrigerant pipe work Insulating the pipes Check the following list and install an oil trapOil trap FfHeight of the oil trap H 4R ≤ H ≤ 6RConnection of refrigerant piping Flare processing Cut the pipe using the pipe cutterRemove burr on the edge of pipe It may cause explosion and injuryTightening of connection parts Pipe bendingDrilling a hole in the wall Outer diameter mm Tightening torque kgf·cmDrain hose Wall installation Corner InstallationFixing the indoor unit ExampleBe sure that all valve cocks are closed Air purgePressure table for temperatures How to add refrigerantRefrigerant charging AP55M0AN AF55GC1M N AF55GP1M N FfCooling operationsIs grounding properly made? Check and test operationCheck Test operation Pump down procedure When removing the productWhen the outdoor temperature is below zero, do not Packing and unpacking guide Outdoor unit To finish How to connect your extended power cablesModel Product specificationQuestions or COMMENTS? Thank you for purchasing this Samsung product Air Conditioner
Related manuals
Manual 54 pages 8.23 Kb

AP55M0ANUMG, AF55GP1MBEENMG, AP55M2ANUMG, AF55GC1MBEENMG, AF55GC1MAEENMG specifications

Samsung has established a reputation for innovation in the realm of technology, particularly with its display solutions. Among its latest offerings in the market are the AP55M0AXUMG, AP55M0BNUMG, AP55M1ANUMG, AF55GC1MAEENMG, and AF55GC1MBEENMG models. These displays cater to various commercial applications, boasting impressive specifications and cutting-edge technologies that enhance user experiences.

The AP55M0AXUMG and AP55M0BNUMG are part of Samsung's premium range, featuring a stunning 55-inch display that utilizes advanced LED technology for vibrant colors and remarkable clarity. Both models support 4K resolution, ensuring that images are sharp and lifelike, which is particularly beneficial for presentations, advertising, and other commercial uses. With an ultra-narrow bezel, these displays maximize the viewing area while maintaining a sleek profile that seamlessly blends into any environment.

Equipped with powerful processors, these displays support seamless multitasking capabilities and real-time content sharing. Their compatibility with various content management systems allows users to create dynamic displays for effective engagement with their audience. The built-in Wi-Fi capabilities ensure easy connectivity, making it simple for users to update content remotely.

The AP55M1ANUMG model takes things a step further by incorporating Samsung's MagicINFO solution, which enables users to manage, schedule, and control multiple screens from a single interface. This feature is particularly advantageous for businesses that require coordinated messaging across multiple locations. Additionally, this model boasts enhanced brightness and contrast ratios, ensuring visibility even in well-lit environments.

On the other hand, the AF55GC1MAEENMG and AF55GC1MBEENMG displays cater to those seeking high-quality performance along with advanced interactive capabilities. Both models employ Samsung's innovative touch technology, allowing users to interact directly with the content displayed. This makes them ideal for educational and collaborative settings, where engagement and interactivity are paramount.

Furthermore, these displays are designed with durability in mind, featuring a robust construction that can withstand various environmental conditions. The energy-efficient design ensures lower operational costs, making them a sustainable choice for businesses looking to reduce their carbon footprint while still delivering high-impact visual experiences.

In conclusion, Samsung's AP55M0AXUMG, AP55M0BNUMG, AP55M1ANUMG, AF55GC1MAEENMG, and AF55GC1MBEENMG models are at the forefront of display technology, providing businesses and educational institutions with the tools they need to communicate effectively and capture audience attention. Their advanced features, combined with Samsung's legacy of quality, make these displays a sagacious investment for any organization seeking to elevate its digital presentation capabilities.
Top Page Image Contents