Samsung AR09FSFPKGMNET For Cleaning, Do not clean the inside of the air conditioner by yourself

Page 9

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

FOR CLEANING

 

 

WARNING

 

 

 

 

 

Do not clean the appliance by spraying water directly onto it. Do not use benzene, thinner or alcohol to clean the appliance.

This may result in discoloration, deformation, damage, electric shock or fire.

Before cleaning or performing maintenance, cut-off the power supply and wait until the fan stops.

Failing to do so may result in electric shock or fire.

ENGLISH

FOR CLEANING

 

CAUTION

 

Take care when cleaning the surface of the heat exchanger of the outdoor unit since it has sharp edges.

To avoid cutting your fingers, wear thick cotton gloves when cleaning it.

Do not clean the inside of the air conditioner by yourself.

For cleaning inside the appliance, contact your nearest service center.

When cleaning the internal filter, refer to the descriptions in the‘Cleaning the air conditioner’ section.

Failure to do may result in damage, electric shock or fire.

9

Maldives ZE_AR09FSFP@_IBIM_DB68-03379A_EN.indd 9

2012-12-8 9:08:55

Image 9 Contents
Maldives ZEAR09FSFP@IBIMDB68-03379AEN.indd 2012-12-8 Contents Important safety symbols and precautions Safety precautionsPersonal injury or death Personal injury or property damageFor Installation Caution For Using Do not touch the circuit breaker with wet hands Do not place objects or devices under the indoor unit Do not operate the appliance with wet hands Do not drink the water from the air conditionerDo not touch the pipes connected with the product Do not clean the inside of the air conditioner by yourself For CleaningChecking before use Operation rangesModel AJ Checking the name of the parts Power buttonMain parts DisplayRemote controller buttons Checking the remote controllerBattery changing time Remote controller displayStoring the remote controller Inserting the batteriesBasic function Press Button to adjust the temperatureUsing the Turbo function Adjusting the air flow directionPress the Air swing button on the remote controller Vertical air flowPress the button on the remote controller When the air conditioner is on and in cool/heat modeMode Press the Time Up or Time Down button to set the timePress the On Timer/Off Timer button Setting the On/Off timerCancel Press the Cancel button Additional options available in On timer modeFrom the moment you have set the timer Using the Smart Saver functionIf the air conditioner is on If the air conditioner is off Turn off automaticallyUsing the Auto Clean function Using the Quiet functionWhen the air conditioner is turned on You can reduce the noise generated from an indoor unitMake sure the power is turned off and unplugged from Cleaning the air conditionerCleaning the indoor unit Cleaning the outdoor unit heat exchangerRemoving the Air filter Cleaning the air filterOpen the panel and put the Air filter out Dry the Air filter in a ventilated areaMaintaining the air conditioner Clean the condensate drain panTroubleshooting Timer function Working Cannot adjust the temperature Fan speedDoes not set After you have set the time Indicator Service centerIncluded Models Remark General informationInstalling the unit Choosing the installation locationPower supply line, fuse or circuit breaker  a place where the air filter can be replaced easilyOutdoor Unit Where sulfide gas existsWhen the air outlet is towards the wall When installing more than 1 outdoor unit Figure Description Top view Side viewAccessories Accessories in the indoor unit caseAccessories in the outdoor unit case Optional accessories Fixing the installation plateTools required for installation General Tools Tools for test operationsConnecting the assembly cable Cable specificationConnecting the cable Each wire is labeled with the corresponding terminal number Extend the assembly cable if necessaryCut off the remaining foam insulation Smooth the cut edgesCutting or extending the pipe Purging the indoor unitUnscrew the caps at the end of each pipe Put a flare nut slightly into the pipe and modify the flareCorrect Inclined Pipe 50 Pa. The joint must be accessible and serviceableCracked Outer DiameterChanging direction of the drain hose Drain hose installationPurging the connected pipes Connect a drain hose to the drain plugEnsure that condensation draining is adequate If you use a pipe longer than 5m Adding RefrigerantIf you use a pipe shorter than 5m ModelPlease fill in with indelible ink  the factory refrigerant charge of the product1975 To check for gas leaks on the outdoor unit Performing the gas leak testsTo check for gas leaks on the indoor unit Leak test with nitrogen before opening valvesThen place the indoor unit on the installation plate Fixing the indoor unit in placeFixing the outdoor unit in place Final Check and Trial Operation Apply heat to the contraction tube to contract it How to connect your extended power cablesAfter tube contraction work is completed, wrap it with Insulation tape to finishWried remote controller, central remote controller etc Sub PCB installationoptionalOnly for multi system Assemble the Cover PCB and the front panelQuestions or COMMENTS? Air Conditioner
Related manuals
Manual 47 pages 43.03 Kb Manual 46 pages 39.71 Kb Manual 45 pages 27.27 Kb Manual 45 pages 23.86 Kb Manual 1 pages 26.59 Kb Manual 1 pages 28.23 Kb Manual 45 pages 14.41 Kb Manual 45 pages 15.07 Kb Manual 45 pages 25.41 Kb