Crimestopper Security Products CS-2012DP-TW1 Second +1 Second, Programmable Option Descriptions

OPTION PROGRAMMING TABLE

20	PINK Wire function		Carjack	*Glow Plug*
21	Starter Cranking Time (Option #16		0.75 Sec.	*0.5 Sec.*	1.0 Sec.	1.5 Sec.
	is set to Timed Crank)
22	Diesel Glow Plug Delay		10 Seconds	*Monitor Glow Plug	20 Seconds	30 Seconds
23	Remote Start Engine Run Time		12 Minutes	*24 Minutes*	36 Minutes	48 Minutes
24	Smart Tachless Voltage Adjustment	-1%		1%	*Set to 93% for
	80-100%				default*
				Pulse When Trigger	*Pulse When*
25	Horn Pulse		Pulse When Trigger		Trigger, Arm/disarm
				and Arm/disarm
					and warning
26	Aux # 3		Steady Momentary	*Momentary*	Timed	Latch On/Off
27	Aux # 3 Time : 1 to 255 sec.		-1 Second	+1 Second	*Default 12 Sec.*
28	Aux # 4		Steady Momentary	*Momentary*	Timed	Latch On/Off
29	Aux # 4 Time : 1 to 255 sec.		-1 Second	+1 Second	*Default 12 Sec.*
30	Reset Options to default (*)			*Reset All Options*

PROGRAMMABLE OPTION DESCRIPTIONS:

1. ENGINE MONITORING:

This option sets how the unit monitors your engine. You can program either for Tach mode in which the unit uses a Tach signal (RPM) or for “Ultra-Smart” Tachless mode that monitors voltage level. See pages 15-16 for more information and additional steps for actual Tach learning and Tach finder modes.

2. AUTOLOCK/UNLOCK W/IGNITION:

Controls whether the doors will automatically lock when the ignition is turned on and unlock when the ignition is turned off. Doors will not lock if they are open to prevent locking the keys in.

3. PASSIVE ARMING Passive Arming With Ignition or Last Door:

With this option ON, the unit will arm itself 30 Seconds after the ignition is turned off and/or the last door has been closed. Lights will flash twice when last door is closed indicating passive countdown. If a door is reopened, the system will wait and begin countdown again when closed. The LED will flash rapidly during 30 second count down.

20