Mitsubishi Electronics 837 Basic TV Operation, Selecting an Input to Watch, Watching Broadcast TV

121. Basic Setup and Operation

Basic TV Operation

Selecting an Input to Watch

1.Press ACTIVITY.

2.Press and to highlight an input.

3.Press ENTER to switch to the input.

Watching Broadcast TV

TV Connected to an Antenna, Direct Cable, Cable Box, Set-Top Box, or Satellite Receiver

1.Select an input to watch from the Activity menu’s Watch TV group.

Note: For more about the Activity menu, see page 21.

Activity menu, antenna input selected

2.Tune to a channel on the ANT input using any of these methods.

•Enter the channel number using the number keys on the remote control and press ENTER.

For a two-part digital channel, such as 3-1,

press 3 — 1 to enter a dash (separator).

CANCEL

•Press CHANNEL UP /CHANNEL DN (+/–) to change channels one channel at a time.

•Press (LAST) to switch back to the previ- ously tuned channel.

•Antenna or Direct Cable Only. Press GUIDE to display ChannelView channel listings, highlight a channel number, and press ENTER to tune.

Watching DVDs or Videos

TV Connected to a DVD Player, DVR, or VCR

Press ACTIVITY and select a movie source from the Activity menu. If you named devices during Auto Input Sensing, select the input from the Watch Movie group.

Activity menu, DVD input selected

TV Tips

Turning the TV On or Off

•Point the remote control at the front of the TV and press the POWER button.

•Press the POWER button on the TV control panel.

If You Turn Off the TV by Mistake

•Press POWER again, within about 60 seconds, to have the TV come back on immediately.

•If the status indicator starts rapidly blinking green (about 60 seconds after you shut off power), wait a few moments for the status indi- cator to stop blinking and press POWER to turn the TV on again.

Controlling Sound Volume

•Press VOLUME UP/VOLUME DN to adjust the sound level.

•See also “Controlling A/V Receiver Sound Volume” on page 22.