101. Basic Setup and Operation
Setting Up TV Inputs
Using the ANT (Antenna) Input
If using an antenna or direct cable service (no cable box), connect the incoming coaxial cable to the TV’s ANT input. Refer to page 18.
You must save channels to memory with a channel scan to enable reception of all available
Memorizing Channels with Channel Scan
For the ANT input
To start channel memorization
1.Power on the TV.
2.Press MENU and open the Initial > Channel menu.
Start channel memorization from the Initial > Channel menu.
3.Press ENTER to enter the menu.
4.Select Ant Air if connected to an
5.Highlight Scan and press ENTER. Channel memorization may take up to 15 minutes to complete.
To stop channel memorization before completion, press CANCEL.
Use the Initial > Channel > Edit menu (page 39) for additional channel options, such as adding or deleting channels from memory.
Setting Up Other Inputs
1.Connect your devices to the TV, making note of which TV input jack is used for each device. See “TV Connections,” page 14, for recommendations.
2.Power on the devices to ensure detection.
3.Power on the TV.
The TV will display the New Device Found screen for each new connection it detects Learn more about Auto Input/Auto Output Sensing on the opposite page.
4.Select the device type if the device is not recog- nized automatically.
Sample New Device
Found screen.
Important Note for NetCommand IR Users
837 Series. Be sure to select the correct device type here. Although you can change the device type later in the Inputs > Name menu, any “learned” Net- Command IR codes will be erased when you make the change.
5.837 Series. You can perform NetCommand IR “learning” after selecting the device type or at a later time when convenient. To perform now, high- light NetCommand and press ENTER. See “Initial NetCommand Setup,” page 47 or “Setting Up A/V Receiver Control,” page 52.
6.Press BACK to close the New Device Found screen. The TV will then display the New Device Found screen for the next connection it finds.