Chauvet 6000X, LEG-6000 user manual Power Cable Configuration

Power

	Your product is equipped with an internal input-voltage select switch.
Warning!	Verify that the power select switch on your unit matches the line voltage applied. All
	fixtures must be connected to circuits with a suitable Earth Ground.
	• To determine the power requirements for		Remove the right base
			cover panel as
		2
	a particular fixture, see the label affixed to
			illustrated here to gain
	the back plate of the fixture or refer to the		access to the switch
	fixture’s specifications chart.		shown below.
	• A fixture’s listed current rating is its
			3
	average current draw under normal
	conditions.

•All fixtures must be powered directly off a

switched circuit and cannot be run off a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0% to 100% switch.

•Before applying power to a fixture, check that the

source voltage matches the fixture’s
requirement.	Input Voltage Switch 3,4,5
• All fixtures must be connected to circuits
with a suitable Earth Ground.

1.Make sure the fixture is not connected to power, if so disconnect.

2.Remove the right base access cover panel as illustrated on the right.

3.Locate the power selection switches and dial.

4.Rotate the voltage dial to the setting that most closely matches the local AC voltage. If your voltage falls halfway between two settings, select the higher voltage on the dial.

5.Move the frequency switch to the setting that matches the local AC frequency; 50 or 60 Hz.

6.Replace access cover.

Power Cable Configuration

CABLE	PIN	INTERNATIONAL
BROWN	Live	L
BLUE	Neutral	N
YELLOW/GREEN	Earth	EG (Ground)

LEG-6000 User Manual 7 Revision: 2007-03-06/09:06