Chauvet LEG-6000 Dip Switches settings explained, Bit Movement, All Off, 1-On, 2-On, 3-On

Appendix

CHANNEL	VALUE	FUNCTION
		Beam Effect
	000 Ù 063	Full Beam
8	064 Ù 127	Frost Filter
	128 Ù 143 Flat and wide beam effect at 0°
	144 Ù 255	Flat and wide beam effect 90° adjustment

9		Zoom
	000 Ù 255	10° > 30°
10		Pan
	000 Ù 255 0° > 570° ( 128 = center)
11		Tilt
	000 Ù 255 0° > 270° (128 = center)
12	000 Ù 255	Pan (Fine)
13	000 Ù 255	Tilt (Fine)
		Control
	000 Ù 007 Utilizes an internal ramp to provide smooth Pan/Tilt
		movement and adjustment
	008 Ù 063 Disables the internal ramp to provide faster Pan/Tilt
		movement and adjustment
	064 Ù 127 Color calibration
14		Pan: Color Wheel
		Tilt: Cyan
		Pan (Fine): Magenta
		Tilt (Fine): Yellow
		( See Appendix, Color Calibration)
	128 Ù 191 Save calibration settings after 3 seconds
	192 Ù 255 Reset all motors after 3 seconds (does not reset calibration)
		Lamp ON/OFF
	000 Ù 047	Standby

15048 Ù 095 Hold 3 seconds for Lamp ON

096 Ù 159 Standby

160 Ù 207	Hold 3 seconds for Lamp OFF
208 Ù 255	Standby

8 Bit Movement

In the 8 bit Pan/Tilt resolution setting both (FINE) channels is removed. All other channel parameters remain the same as in the “DMX Channel Values” table.

CHANNEL	FUNCTION		CHANNEL	FUNCTION		CHANNEL	FUNCTION
1	Dimmer	6		Yellow	11		Tilt
2	Shutter/Strobe	7		Color Macro	12		Control
3	Color Wheel	8		Beam	13		Lamp ON/OFF
4	Cyan	9		Zoom
5	Magenta	10		Pan

Dip Switches (settings explained)

DIP SWITCH	EVENT	NOTES
	The lamp will strike first. If striking of the lamp succeeds, in approximately
All Off	15 seconds the fixture’s motors will be powered and initialized. If the lamp	This is the default setting on the fixture and
	does not strike, the remainder of the fixture will not initialize and you will	helps in reducing the amount of striking or
	not have control of the fixture. Please wait 15 minutes before re-	inrush current used by the fixture upon startup.
	starting the fixture, otherwise perform a service check.
1-On	Lamp and motors are powered at the same time.	Will consume the most amount of inrush current
		in the startup phase.
2-On	Only the lamp will turn on in the fixture
1-On, 2-On
3-On	This switch will terminate the dmx connection.	Use only at the end of a DMX daisy chain.

LEG-6000 User Manual 16 Revision: 2007-03-06/09:06