EdgeStar AP12000S-1 owner manual Attaching the duct connectors to the exhaust hose

Page 10

Attaching the duct connectors to the exhaust hose



A.

B.

5.Attach the connectors to the hose: A. Extend the ends of the exhaust hose

B. Thread the duct connector on by turning it clockwise until it stops.



2
0
	”

6.Roll the unit towards the window kit. Leave a space that is at least 20 inches to the wall.

7

Image 10

Contents AP12000S-1 Important Safety Information Electrical SafetyTable of Contents Introduction For Your RecordsFront View Control Panel Parts IdentificationBack View Pre-filter Installing the Carbon Filter Window Kit Installation Instructions Preparations for installing the window kitInstalling the grated adapter Installing the window plates Attaching the duct connectors to the exhaust hose Connecting the duct connector to the unit Connecting the duct connector to the grated adapterDraining the Unit Direct drainageButton IndicatorControl Panel Overview FunctionDehumidifying Mode PowerCooling Mode Operating the Control PanelLCD Display Fan Only ModeSpeed Timer Water LightPower Button Mode Button Using the Remote ControlTimer Button Buttons Function Energy Saving Guide Cleaning the pre-filter MaintenanceCleaning the unit Preparation for StorageTroubleshooting Issue Possible Cause SolutionTroubleshooting Issue Possible Cause SolutionSpecifications EdgeStar Limited Warranty One 1 Year Parts & Ninety 90 Days Labor