EdgeStar AP12000S-1 owner manual Important Safety Information, Electrical Safety

Page 2

Important Safety Information

Improper handling can cause serious damage to the appliance and/or to the user. Please read the following safety information.

Electrical Safety

This unit is designed for indoor use only.

Do not use the unit in extremely humid or wet environments.

Do not spray water and wet the housing or control panel.

Do not pull the unit by the cord.

Always turn the unit off and unplug it from the outlet when cleaning.

Unplug the unit if it is not going to be used for a long period of time.

Do not operate the unit with a damaged plug or a loose socket.

Use only the correct power supply with appropriate amperage.

If the power cord is damaged, it must be replaced by the manufacturer, a service agent, or qualified technician.

Do not remove any part of the casing unless instructed by an authorized technician.

General Safety

This portable air conditioner is not intended to be used by children.

Children should be supervised to ensure that they do not play with this product.

Do not allow children to play with the controls or drop any objects into the air outlets or vents.

Do not place objects or let any person sit on top of the unit.

Only use in the upright position on a flat, level surface and provide at least 20 inches of clearance from any walls or objects.

Route the power cord carefully to avoid a tripping hazard.

This unit is intended for domestic use only. Do not use the portable air conditioner for industrial or commercial use. Any other use may invalidate the warranty.

RESET

TEST

Your portable air conditioner is supplied with a Leakage-Current Detection and Interruption (LCDI) safety plug. This device provides protection to reduce the risk of fire due to arcing faults in the power supply cord. Before using your portable air conditioner, follow the instructions below to ensure that the LCDI plug is working properly:

1.Plug the power cord to a grounded outlet.

2.Press the TEST button on the LCDI plug. This should trip the plug and cut the power to the air conditioner. If the plug does not trip and you are able to turn on the unit, please contact EdgeStar support.

DO NOT USE YOUR PORTABLE AIR CONDITIONER IF THE TEST FAILS.

Press the RESET button to start using your air conditioner.

Do not use the TEST and RESET buttons as an ON/OFF switch.

Electrical products should not be disposed of with household waste. Please contact your local recycling center for more information on how to recycle electronic waste.

i

Image 2
Contents AP12000S-1 Important Safety Information Electrical SafetyTable of Contents Introduction For Your RecordsBack View Pre-filter Parts IdentificationFront View Control Panel Installing the Carbon Filter Window Kit Installation Instructions Preparations for installing the window kitInstalling the grated adapter Installing the window plates Attaching the duct connectors to the exhaust hose Connecting the duct connector to the unit Connecting the duct connector to the grated adapterDraining the Unit Direct drainageButton IndicatorControl Panel Overview FunctionDehumidifying Mode PowerCooling Mode Operating the Control PanelLCD Display Fan Only ModeSpeed Timer Water LightTimer Button Buttons Function Using the Remote ControlPower Button Mode Button Energy Saving Guide Cleaning the pre-filter MaintenanceCleaning the unit Preparation for StorageTroubleshooting Issue Possible Cause SolutionTroubleshooting Issue Possible Cause SolutionSpecifications EdgeStar Limited Warranty One 1 Year Parts & Ninety 90 Days Labor