Oreck FC1000 Dirt Sensor, Power Nozzle Handle Positions, Floor Surface Selector Carpet and Rug

Use	Dirt Sensor
	• The Dirt Sensor will turn red (J) when the power
	nozzle is detecting and picking up dirt. The light will
	turn green when no dirt is detected.

Power Nozzle Handle Positions

•The handle has two positions when used with the power nozzle: upright and operating.

•The handle is locked when in the upright position.

•To lower handle to operating position, press the Handle

Release pedal (K) on the back of the power nozzle and pull the handle back.

Floor Surface Selector

•Carpet and Rug

•When using the power nozzle for carpet and rug cleaning, push the floor surface selector switch to

“ON” (L). This setting provides the suction and brushroll action necessary to deep clean carpets.

NOTE: The surface selector switch must be in the “OFF” position before turning the vacuum on.

•Hard Surfaces

•The power nozzle can be used for cleaning hard surfaces such as wood, linoleum, vinyl, rubber, tile, sealed cork, and terrazzo.

	IMPORTANT: Follow flooring manufacturer’s
8	recommendations for cleaning.