Maintenance - continued
•If there is no blockage in the hose. Remove the power nozzle from wand and attach wand to hose. Check for suction and remove any blockages.
Nozzle Blockage
•If the nozzle becomes clogged, use the following procedures to check for and clear the blockage.
•If blockage is severe enough the nozzle will shut off. After the blockage is cleared you must push the Overload Protection Reset button (A) before the nozzle will operate again.
•Make sure power nozzle is disconnected from wand. Then check for blockage in nozzle connection (B).
•There is an additional panel on the bottom of the nozzle (C). This opening provides a secondary place to check and clear blockage.
20