Oreck FC1000 manual Replace Brushroll Cover, Step Replace Nozzle Hood

Page 21

Maintenance - continued

Replace Brushroll Cover

•Place brushroll cover back over the brushroll.

•Replace the two cover screws.

Step 8

Replace Nozzle Hood

•The wand must be in the upright locked position.

•Position the hood on top of nozzle base. Make sure wires and buttons are aligned. Do not force the hood on.

•Turn the nozzle over.

•Replace the seven screws for the hood. See Step 1.

Step 9

When to Replace the Brushroll

•When brushroll bristles are worn, the brushroll should be replaced.

•To check condition of the bristles, hold a card on the bottom plate while turning the brushroll. Replace the brushroll if bristles do not touch the card.

ALWAYS DISCONNECT

VACUUM FROM

ELECTRICAL OUTLET

BEFORE STARTING

THIS PROCEDURE!

Image 21

Contents User’s Guide USA 1 800 989 Canada 1 888 676To find the nearest location, please call 888oreck store 1 888 673Contents Safety Environment Save These Instructions 25 26 27 Nozzle Top View 17 16 Parts Product Components & AccessoriesAssembly ON/OFF Switch Check Bag IndicatorVariable Suction Control Connect Hose Connect Hose Handle to WandConnect Wand to Nozzle Dirt Sensor Power Nozzle Handle PositionsFloor Surface Selector Carpet and Rug Hard SurfacesBrushroll Carpet Height Adjustment & IndicatorCleaning Tools Attaching Tools Cleaning StairsBag Full Indicator MaintenanceRemove Bag Open the VacuumInstall New Bag Complete the InstallationRemoving and Cleaning the Motor Filter Remove Nozzle Hood Screws Replace the Hepa Media FilterStep Remove Nozzle HoodStep Remove Brushroll Cover Check/Remove Belt Step Remove/Replace BeltStep Replace Brushroll Step When to Replace the Brushroll Replace Brushroll CoverStep Replace Nozzle Hood How to Replacing the Headlight How to Replace the BrushrollHow to Clear Blockages Hose/Wand BlockageNozzle Blockage Trouble- shooting Warranty Page Page REV a 09/10 ECN R-10179