How to Replace the Brushroll, How to Clear Blockages

Maintenance - continued

How to Replace the Brushroll

DISCONNECT VACUUM FROM ELECTRICAL OUTLET!

1.Remove hood, brushroll cover, belt and brushroll. See Steps 1-6.

2.Discard the old brushroll.

3.Install the new brushroll and belt. See Steps 7-9.

How to Replacing the Headlight

•The headlight is located inside of the power nozzle.

The light is on whenever the vacuum is turned on.

1.Disconnect power nozzle from the extension wand.

2.Remove the hood. See Steps 1-2.

3.Pull the old bulb from the socket to remove. Push the new bulb into socket.

4.Replace the hood. See Steps 9 & 1.

ALWAYS DISCONNECT

VACUUM FROM

ELECTRICAL OUTLET

BEFORE STARTING

THIS PROCEDURE!

How to Clear Blockages

•Low suction or pick up may be due to a blockage in the system. Refer to the following steps to check for blockages, continuing with each step until the blockage is found.

Hose/Wand Blockage

•Disconnect power nozzle and wand from handle.

•Plug vacuum in and turn it on. Check the hose end for suction. Remove any obstructions.