E N G L I S H
5. Many times blockage occurs | F | |
due to a full dust bag | ||
| ||
causing dirt to back down | Connector | |
the air flow system. When | Deflector | |
that happens, the blockage | Opening | |
will be at the top of the |
| |
system, starting in the area |
|
To Adjust or Replace Brush
WARNING: Unplug cord from electrical outlet before servicing.
where the dust bag connects |
to the connector assembly. |
See illustration F. |
NOTE: If the above actions do not correct the problem, contact an ORECK authorized service center or call the commercial
customer service center. Commercial:
IMPORTANT: On plush and new carpets, stuffing may occur due to excessive fuzz and loose cuttings in the carpet. Stuffing could occur for the first few cleanings until all the loose material is removed. Due to the high efficiency of the cleaner, many older carpets will cause stuffing when the cleaner is first used on them.
Using An Oreck Fresh Air® Tab
Your ORECK XL vacuum cleaner has a special FRESH AIR tab pocket. This pocket is located inside the outer bag in the area where the disposable paper bag attaches to the intake tube. Insert tablet in pocket.
Grounding Instructions
Rotate and match |
bearing assemblies |
To determine if the brush is worn, place a firm straight edge across the nozzle opening. If brush bristles do not extend beyond baseplate, brush should be adjusted.
Remove the baseplate by removing 5 screws. Then, remove the belt and brush roll from the housing.
Rotate both bearing assemblies at ends of brush roll to show “OLD” and replace in the holding channels in the housing.
NOTE: The bearing assembly setting marked “OLD” has two notches ( ll ) on the top of the assembly. The one marked “NEW” has one notch
( l ). When rotating bearings, make sure both bearing assembly settings are the same and face up when replacing the brush roll.
This appliance must be grounded. If it should malfunction or break down, grounding provides a safe path of least resistance for electrical current, reducing the risk of electric shock. The cord for this appliance has an
DANGER: Improper connection of the
This appliance is for use on a nominal
Grounding Pin
Grounded Outlet
IMPORTANT: Unless the brush is worn as indicated above, both bearings must be in the “NEW” position. When rotating, both bearings must be in the “OLD” position. Unmatched settings will cause damage to your machine.
Reassemble the belt and the baseplate and check bristle height above baseplate at each end of brush.
If a previous adjustment has already been made and bristle height does not extend above baseplate, a new brush assembly should be ordered.
7