Wire the Light Control
WARNING: Turn power off at circuit breaker or fuse.
❒Remove the existing light fixture.
❒Install the mounting strap as shown using two screws that fit your junction box.
❒The plastic hanger can be used to hold the fixture while wiring. The small end of the plastic hanger can be threaded through the hole in the center of the cover plate. The small end then goes into one of the slots on the mounting strap.
❒Route the light control’s wires through the large gasket holes.
❒Twist the junction box wires and fixture wires together as shown. Secure with wire connectors.
Mounting |
|
|
|
Black to |
| White to | |
Strap | Black |
| White |
|
|
|
|
Rubber
Plug
Mounting
Bolt
Gasket
Junction box ground wire to green ground screw on fixture.
Mount the Light Control
❒Align the light control cover plate and cover plate gasket. Secure with the mounting bolt.
❒For model
Shell Slot
❒Push the rubber plug firmly into place.
❒If a wet location junction box was not used, caulk the wall plate mounting surface with silicone weather sealant.
To avoid water damage and electrical shock, keep bulb holders 30° below horizontal.
| Keep bulbs at least |
| 1" (25 mm) from the |
Lock Nut | sensor. Do not allow |
| the bulbs to block |
Lens | the lens. |
❒Adjust the bulb holders by loosening the lock nuts but do not rotate the bulb holders more than 180° from the factory setting.When screwing in the floodlamps, do not overtighten.