NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
C.) AIR OUTPUT FILTER, LINT FILTER
REPLACE EVERY 500 HOURS OF OPERATION OR ONCE A YEAR.
-Remove upper shell and fan guard (See page 9).
-Remove end filter cover screws using medium phillips screwdriver.
-Remove end filter cover.
-Replace air output and lint filter.
-Reinstall end filter cover.
-Reinstall fan guard and upper shell.
Air Output Filter |
Intake |
Filter |
End filter cover |
Lint Filter |
Figure 11.
D.) FAN BLADES |
|
| |
CLEAN EVERY SEASON OR AS NEEDED. | Set screw |
| |
- Remove upper shell (See page 9). | Motor Shaft |
| |
- Use M6 allen wrench to loosen set screw | Set screw |
| |
which holds fan blade to motor shaft. |
|
| |
- Slip fan blade off motor shaft. | Motor Shaft |
| |
- Clean fan blade using a soft cloth |
| ||
| Flush | ||
moistened with kerosene or solvent. |
| ||
|
| ||
- Dry fan blade thoroughly. | Fan Blade | Fan | |
- Reinstall fan blade on motor shaft. Place | |||
Blade | |||
| |||
fan blade hub flush with end of motor shaft. |
|
| |
- Place set screw on flat of shaft. Tighten set screw firmly |
| ||
Figure 12. |
| ||
- Reinstall upper shell.
E.) NOZZLE
REMOVE DIRT IN NOZZLE AS NEEDED (SEE PAGE 16). (For
-Remove upper shell (See page 9).
-Remove fan blade (See Section D above).
-Remove fuel and air line hoses from burner head.
-Remove ignitor wire from spark plug.
-Remove three screws using medium phillips screwdriver and
remove burner head from | Combustion | Nozzle Face |
| |
combustion chamber. | Chamber |
| ||
|
|
| ||
- Remove spark plug from burner | Screw | Nozzle |
| |
head using medium phillips |
| |||
Burner head |
|
| ||
screwdriver. |
|
| ||
|
|
| ||
- Carefully remove nozzle from | Spark Plug |
|
| |
|
|
| ||
burner head using 5/8” socket | Ignitor Wire |
|
| |
wrench. |
|
|
| |
- Blow compressed air through face |
|
|
| |
of nozzle. (this will remove any |
| Burner |
| |
dirty in nozzle) | Fuel Line Hose | Fuel Line Fitting | ||
Head | ||||
| ||||
- Reinstall nozzle into burner head |
|
| Air Line Fitting | |
and tighten firmly. (80~110 inch- | Air Line Hose |
| ||
|
| |||
pounds) |
|
|
| |
- Reinstall spark plug in burner head. |
| Figure 13. |
| |
|
|
|
-Attach burner head to combustion chamber.
-Attach ignitor wire to spark plug.
-Attach fuel and air line hoses to burner head.
-Reinstall fan blade and upper shell.
10