Desa Tech CGD3924N, CGD3018N, CGD3930N installation manual Installing Logs

INSTALLING	INSTALLING LOGS
Continued	WARNING
	Failure to position the parts in accordance with these diagrams or failure
	to use only parts specifically approved with this heater may result in
	property damage or personal injury.

Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1.Locate pegs on the bottom of back log (#1). Slide these pegs into the holes in the grate base behind the burner (see Figure 16).

2.Place the base of the middle log (#2) in the U-shaped slots of the grate base in front of the back log. The cutout on the right of the middle log should fit over the burner (see Figure 17). Make sure the front of the middle log is resting on the tabs of the grate base and the cutout area is centered over the burner “U” bend.

3.Locate the recesses on the back of the front log (#3). Fit these recesses between the posts of the grate base (see Figure 18).

4.Locate the notches in the bottom of the crossover log (#4). Place the crossover log on top of the middle log and front log. Make sure the notches of the cross- over log lines up with rectangular knobs on top of the middle and front logs (see Figure 19).

Back Log (#1)		Middle Log (#2)
Peg
Hole in	Tab
Grate Base
	Burner
		Cutout
		“U” Bend
		U-Shaped
		Slot
Figure 16 - Installing Back Log (#1)	Figure 17 - Installing Middle Log (#2)
Front Log (#3)	Notches	Crossover
		Log (#1)

	Recess
Post
Post	Rectangular
	Knobs
Figure 18 - Installing Front Log (#3)	Figure 19 - Installing Crossover Log (#4)

19

102986