Desa FSBVBPC, FSBVBNC installation manual REMOVING/REPLACING Glass Door, Installing Remote Receiver

OWNER’S MANUAL

STOVE AND B-VENT BURNER SYSTEM INSTALLATION

Continued

INSTALLING OPTIONAL WIRELESS HAND-HELD REMOTE CONTROL ACCESSORIES - GHRC AND GHRCTA SERIES

NOTICE: Only use alkaline batter- ies (not included).

Installing Remote Receiver

1.Open bottom door on stove body and locate the switch plate on the left of the valve bracket.

2.Disconnect wires from THTP and TH on control valve that lead to the switch (see Figure 36, page 16). Discard switch plate, screws, and nuts.

3.Install 9-volt battery (not included) into receiver battery clip and connect to ter- minals (see Figure 39).

4.Place receiver into valve bracket and align holes (see Figure 40).

5.Use push-in fasteners included with receiver to secure to bracket.

6.Connect the wires from the receiver to the valve at TH and THTP (see Figure 36, page 16).

Receiver

Terminal

Wires

Battery Clip

9-Volt Battery

Figure 39 - Installing Battery in Receiver

LO

H

I

OFF	L
	P
	I
ON	O
	T

Figure 40 - Installing Remote Receiver

Installing 9-Volt Battery in Hand- Held Remote Control Unit

1.Remove battery cover on back of re- mote control unit

2.Attach terminal wires to a 9-volt bat- tery (not included). Place battery into the battery housing.

3.Replace battery cover onto remote con-

trol unit.

Battery Remote

Terminal	Cover	Control Unit
Wires

9-Volt Battery

Battery

Housing

Figure 41 - Installing Battery in Hand- Held Remote Control Unit (GHRC Series)

Terminal	Remote
	Control Unit
Wires

9-Volt Battery

	Battery
Battery Housing	Cover

Figure 42 - Installing Battery in Hand-Held Remote Control Unit (GHRCTA Series)

REMOVING/REPLACING GLASS DOOR

You must remove glass door to install logs, lava rock, and ember material. To remove glass door, you must first remove the front panel on stove body.

CAUTION: Do not operate this burner system with a broken glass door panel or without the glass door panel securely in place. For replacement part in- formation see Replacement Parts, page 26.

1.Remove 2 bolts from bottom of stove (if still in place) and one from the top of stove to remove front panel (see Fig- ure 43).

2.Remove the screws from the 2 tabs at the top of the glass door while holding door securely keeping it from falling forward (see Figure 44).

3.Grasp door by both sides and ease it upward off of the lower bracket (see Figure 44).

4.To replace glass door, follow the above instructions in reverse.

Bolt

Bolt

Stove Front Panel

Assembly

Figure 43 - Removing Front Panel from Stove

Screw

Glass Door

Figure 44 - Removing Glass Door from Burner System

Continued

107600 17 For more information, visit www.desatech.com