INSTALLATION
Continued
Single Burner Seasonal Oak Models CRL2718P/N, CRL2718P/N
WARNING:Failuretoposition thepartsinaccordancewiththese diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
The Seasonal Oak Log Set is a reversible log set. This means that the two bottom logs may be turned to face either direction. The top log, however, must remain in the same position. Do not modify logs. Only use logs supplied with heater.
1.Place the back log onto the back of the base assembly. Make sure log sits forward against the two posts in front of log (see Figure 32). This log may be turned to face either direction.
2.Place front log onto grate on front of base as- sembly. The log will fit down between grate fingers and posts on front of base assembly (see Figure 33). This log may be turned to face either direction.
3.Place the crossover log on top of the back log and front log making sure pins are inserted into holes on top of logs 1 and 2 (see Figure 34). This log must be placed as shown in Figure 34 or the pins will not seat into holes.
4.Add lava rock around base of heater if desired. Do not put lava rock on logs or burner.
Back Log
Post
Base
Assembly
Post
Figure 32 - Installing Back Log
Front Log
Post
Grate |
|
Fingers | Post |
Base | |
Assembly |
|
Figure 33 - Installing Front Log
Crossover Log
Hole in
Front LogHole in
Back Log
Figure 34 - Installing Crossover Log
www.desatech.com | 19 |