setting up your washing machine
Connecting the drain hose
The end of the drain hose can be positioned in three ways:
1.Over the edge of a wash basin: The drain hose must be placed at a height of between 60 and 90 cm. To keep the drain hose spout bent, use the supplied plastic hose guide. Secure the guide to the wall with a hook or to the tap with a piece of string to prevent the drain hose from moving.
2.ln a sink drain pipe branch: The drain pipe branch must be above the sink siphon so that the end of the hose is at least 60 cm above the ground.
Drain hose |
Hose guide 
60 ~ 90 cm
3.ln a drain pipe: We recommend using a 65 cm high vertical pipe; it must be no shorter than
60 cm and no longer than 90 cm. The standpipe drain requires;
• minimum diameter 5 cm.
• minimum
60 ~ 90 cm
STEP 5
Powering your washing machine
Plug the power cord into a wall sockets, an AC
Test run
Make sure that you install your washing machine correctly by running the Rinse+Spin cycle after the installation is complete.
STEP 6
Calibration mode
Samsung washing machine detects the laundry weight automatically. For more accurate weight detection, please run Calibration Mode after the installation. Calibration mode is done by following the steps below.
1.Remove laundry or any contents in the machine and turn off the machine.
2.Press the Temp button and Delay End button simultaneously, and press the Power button in addition. Then the machine turns on.
3.Press the Start button to activate “Calibration Mode”.
4.The drum rotates clockwise and counterclockwise approximately for 3 minutes.
5. When “Calibration Mode” is finished, “END(En)” appears on the display, and the machine automatically turns off. The washing machine is now ready for use.
20_ setting up your washing machine