Samsung NV70J7554KS/ML manual Nstallation in the cabinet

nstallation in the cabinet

With built-in furniture, plastic surfaces and adhesive for the oven should be resistant to 90 °C inside of the furniture and to 75 °C for adjacent furniture. Samsung will take no responsibility for damage of plastic surfaces or adhesive from the heat.

There should be a ventilation gap in the base of the kitchen cabinet where the oven is to be placed. For ventilation, a gap of about 50 mm should be left between the lower shelf and the supporting wall. If the oven is to be installed below a hob, the hob’s installation instructions should be followed.

	Min.550	Min.560
		Min.50
370	560
Max.50		Min.590 ~ Max.600
595	572 550
595	545
	21
		Min.460 x Min.50
Built-in

			Min.550		Min.560
370		175		560		02INSTALLATION
595	85
					Min.600
				572 550
Max. 506
595	Max.			545	Min.460 x Min.50
	494		21		Built-under
					Built-in + Built-under

Push the appliance completely into the cabinet and fix the oven firmly on both sides using 2 screws. Make sure that a gap of at least 5 mm should be left between the appliance and the adjacent cabinet.

After installation, remove the vinyl protective film, tape, paper and accessories from the door and inside of oven. Before uninstalling the oven from the furniture, disconnect the oven from the power supply and release the 2 screws on the both sides of the oven.

WARNING: The built-in furniture must have a minimum ventilation gap for Air-flow as shown on picture. Do not cover this hole with strips of wood, for this is used to provide ventilation.

The front exterior of the oven such as handle is different model by model. But the size of the oven in the picture is same.

English - 11

NV70J7554KS_ML_DG68-00607B-00_EN.indd 11

2015-11-04 ￿￿ 11:06:01