Quadra-Fire QVI-30FB To service or clean, Junction box installation, Serving the blower

Page 18

	INSERT STRAIN RELIEF	To service or clean:
	INSERT STRAIN RELIEF	• Remove the ground wire of the fan can clip on the side of
	AROUND CORD IN THIS END	• Remove the ground wire of the fan can clip on the side of
	FROM OUTSIDE OF UNIT	the base pan.
FEED PLUG		the base pan.
THROUGH HOLE	SIDEWALL	• Remove the blower in between the bend up tabs.
	SIDEWALL

		• Install and wire the blower per instruction shipped with
		the fan.
		• Reinstall the blower in reverse order. Make sure the fan
		does not make contact with the back wall.
JUNCTION
BOX
Figure 9.	SCREW
Figure 9.	PROVIDED
Junction box installation			FAN	COVER
			FAN	COVER
				PLATE
Serving the blower
On units already installed removal of decorative front, sur-
round and gas insert is required.
• Detach flexible liner from the top of unit.
• Remove the four screws on the coverplate (see Figure 11).		Figure 11.	GROUND
• Bend up the tabs on the base pan (see Figure 10).		Figure 11.	WIRE
• Bend up the tabs on the base pan (see Figure 10).
	VARIABLE SPEED CONTROL	REMOTE
	VARIABLE SPEED CONTROL	RECEPTACLE

	JUNCTION BOX
BLK	BLK
BLK
	BLK
		BLK
BLK
BLK	BLK
BLK
	WHT	WHT
	BLK
	GROUND
TEMPERATURE
SENSOR SWITCH	GRN
	BLK	WHT
	110-120 VAC
		FAN

NOTE: IF ANY OF THE ORIGINAL WIRE AS SUP- PLIED WITH THE APPLIANCE MUST BE RE- PLACED, IT MUST BE REPLACED WITH TYPE 1050 C RATED WIRE.

Figure 10. Fan Wiring Diagram	BEND UP
	TABS

BLOWER RECEPTACLE

BLOWER

REMOTE
OUTLET	JUNCTION
	BOX
	FAN
	OUTLET

TEMPERATURE

SENSOR SWITCH

SPEED CONTROL

(RHEOSTAT)

GROUND WIRE

(ATTACH TO ANY METAL SURFACE)

18	Quadra-Fire • QVI-30FB • 2020-900 Rev. H • 9/07

Image 18

Contents QVI-30FB What to do if you smell gasSafety and Warning Information Table of Contents Service Parts Log Set AssemblyService Parts List Standing Pilot Valve Assembly Appliance Certification High Altitude InstallationsInstallation Codes CertificationRequirements for the Commonwealth of Massachusetts Vent Directly BELOW. Keep Clear of ALL OB- StructionsManufacturer Requirements Pre-install Preparation Introducing the Quadra-Fire Gas AppliancesDiagram of insert and minimum fireplace dimensions Diagram and model dimensions Installing the Vent System Rectly to the Exhaust Collar of the UnitHorizontal Overhang Minimum Height from Roof to Lowest Discharge OpeningFactory installed to Stainless steel section Typical configuration of vent liners Gas Supply Line Positioning, Leveling, Securing the InsertGas Control System Connected to a Control Valve in a Millivolt SystemGas Pressure Requirements Wiring the FireplaceStanding Pilot Ignition Wiring Diagram Pressure Natural Gas PropaneTo service or clean Junction box installationServing the blower Shutter Settings Installing Logs and Ember MaterialInstalling Trim Surrounds Positioning the LogsDouble-check for faulty components Before Lighting the ApplianceDouble-check vent terminations for obstructions Standing Pilot Ignition After the InstallationLighting the Appliance What to do if YOU Smell GASImportant Turn OFF the GAS Before Servicing Your Fireplace Appliance MaintenanceCleaning Glass Door Replacing old ember materialTroubleshooting Be Placed in this Opening Lifetime Warranty