Quadra-Fire QVI-30FB owner manual Standing Pilot Valve Assembly

Page 6

Service Parts	QVI-30FB

Valve Assembly Parts Diagram

Standing Pilot Valve Assembly

6

7

1

8

2

9

3

4

5

10

IMPORTANT: THIS IS DATED INFORMATION. The most current information is located
				AVAILABLE
on your dealers' VIP site. When ordering, supply serial and model numbers to ensure				AVAILABLE
				TO SHIP IN
correct service parts.				TO SHIP IN
correct service parts.				24 HOURS
				24 HOURS
ITEM	DESCRIPTION	SERIAL #	PART NUMBER
1	Flex Ball Valve Assembly		302-320A	Y
2	Valve NG		060-522	Y
2	Valve LP		060-523	Y
	Valve LP		060-523	Y
3	Pilot control Knob		571-530

4	Flame Control Knob		571-531
5	Valve Bracket		773-145

6	Pilot Assembly NG		485-510A	Y
6	Pilot Assembly LP		485-511A	Y
	Pilot Assembly LP		485-511A	Y
7	Orifice NG (#31A)		506-800	Y
7	Orifice LP (#49A)		065-801	Y
	Orifice LP (#49A)		065-801	Y
8	Bracket, Orifice		778-169

9	Bracket, Pilot		783-170

10	Flexible Gas Connector		477-301A	Y

6	Quadra-Fire • QVI-30FB • 2020-900 Rev. H • 9/07

Image 6

Contents QVI-30FB What to do if you smell gasSafety and Warning Information Table of Contents Service Parts Log Set AssemblyService Parts List Standing Pilot Valve Assembly Appliance Certification High Altitude InstallationsInstallation Codes CertificationRequirements for the Commonwealth of Massachusetts Vent Directly BELOW. Keep Clear of ALL OB- StructionsManufacturer Requirements Pre-install Preparation Introducing the Quadra-Fire Gas AppliancesDiagram of insert and minimum fireplace dimensions Diagram and model dimensions Installing the Vent System Rectly to the Exhaust Collar of the UnitHorizontal Overhang Minimum Height from Roof to Lowest Discharge OpeningFactory installed to Stainless steel section Typical configuration of vent liners Gas Supply Line Positioning, Leveling, Securing the InsertGas Control System Connected to a Control Valve in a Millivolt SystemGas Pressure Requirements Wiring the FireplaceStanding Pilot Ignition Wiring Diagram Pressure Natural Gas PropaneTo service or clean Junction box installationServing the blower Shutter Settings Installing Logs and Ember MaterialInstalling Trim Surrounds Positioning the LogsDouble-check for faulty components Before Lighting the ApplianceDouble-check vent terminations for obstructions Standing Pilot Ignition After the InstallationLighting the Appliance What to do if YOU Smell GASImportant Turn OFF the GAS Before Servicing Your Fireplace Appliance MaintenanceCleaning Glass Door Replacing old ember materialTroubleshooting Be Placed in this Opening Lifetime Warranty