Quadra-Fire SANTAFEI-CE-MBK owner manual Venting Systems, Full Reline With Horizontal Outside Air

Page 26

Castile & Santa Fe CE Insert

R

8 Venting Systems

A. Full Reline With Horizontal Outside Air

CAUTION

Never draw outside combustion air from:

Wall, floor or ceiling cavity

Enclosed space such as an attic or garage

WARNING

Fire Risk.

Inspection of Chimney:

Masonry chimney must be in good condition.

Meets minimum standard of NFPA 211

Factory-built chimney must be a minimum 152mm UL103 HT.

NOTE; Use metal plate around exhaust vent pipe and seal all edges with non-flammable insu- lation such as , mineral wool or ceramic.

Do not use high temperature caulking materials to seal any edge to prevent future service- ability.

NOTE; Use metal plate around exhaust vent pipe and seal all edges with non-flammable insu- lation such as fiberglass, mineral wool or ceramic.

Do not use high temperature caulking materials to seal any edge to prevent furture service- ability.

Outside Air through Rear Wall (Horizontal)

Outside Air through Rear Wall (Horizontal)

Figure 28.1

Figure 28.2

NOTE:

Illustrations reflect typical installations and are FOR DESIGN PURPOSES ONLY.

Illustrations/diagrams are not drawn to scale.

Actual installation may vary due to individual design preference.

Page 26

7069-101B

October 27, 2011

 

 

Image 26
Contents Castile & Santa FE Pellet Insert Hot glass will cause burnsCastile & Santa Fe CE Insert Welcome to the Quadra-Fire FamilyTable of Contents Castile & Santa Fe CE Insert Castile & Santa Fe CE Insert Listing and Code Approvals SpecificationsGlass Specifications Appliance CertificationUser’s Guide Operating InstructionsFuel Material and Fuel Storage Castile & Santa Fe CE Insert Fire SafetyCombustible/Non-Combustible Materials Filling the Hopper with Fuel Castile & Santa Fe CE Insert General Operating InformationBefore Your First Fire Thermostat Calls For HeatFeed Adjustment Control Rod Wing Nut Set Screw Fire CharacteristicsFeed Rate Adjustment Instructions Castile & Santa Fe CE Insert Starting Your First FireCastile & Santa Fe CE Insert Ignition Cycles Clear Space Do not Leave Firepot Floor OpenQuick Reference Maintenance Chart Types of FuelSee .1 on Disposal of Ashes Frequency As needed Cleaning Firepot with Cleaning Rod & Firepot Clean-Out ToolCleaning Ash Pan/Drawer Ash Removal from FireboxCleaning the Hopper Cleaning Heat Exchanger Chambers & Drop TubeCleaning Beneath Heat Exchanger Cleaning the GlassDoor Latch Inspection Cleaning Combustion Blower Requires No LubricationPreparing Firebox for Non-Burn Season Task Contact your local dealerTall, Lazy Flame, Orange in Color Troubleshooting for Homeowner Frequently Asked QuestionsFloor Support Getting StartedAppliance Location Pre-Burn Check List Castile & Santa Fe CE Insert Thermostat LocationTools And Supplies Needed Inspect Appliance and ComponentsDimensions and Clearances Appliance DimensionsPrefabricated Metal Chimney Minimum Opening for Masonry and Factory-Built FireplacesCastile & Santa Fe CE Insert Floor Protection Venting Termination Requirements Negative Pressure, Shut-Down and Electrical Power FailureVent Information Avoiding Smoke and OdorsDraft Vent ConfigurationsNegative Pressure Minimum Vacuum Requirements 095Castile & Santa Fe CE Insert Chimney and Exhaust Connection Castile & Santa Fe CE Insert Pellet Venting Charts Miniumum Vertical Vent for Two ElbowsVenting Systems Full Reline With Horizontal Outside AirOutside Air Termination At Chimney Top Outside Air Kit Instructions Appliance Set-UpLeveling System Door Removal Adjustable Hearth SupportCastile & Santa Fe CE Insert Door Handle Removal Install Front Last Surround & Trim Set, Econo 34.2Castile & Santa Fe CE Insert Surround and Cast Trim Set Sheet metal screws on each side provided with the kitCastile & Santa Fe CE Insert Panel and Trim Set Completed ViewTwo Piece Log Set Installation Castile & Santa Fe CE Insert Thermostat Installation Contact Information