Quadra-Fire CASTILEI-CE-MBK, SANTAFEI-CE-MBK owner manual Surround & Trim Set, Econo, 34.2

R

Castile & Santa Fe CE Insert

F. Hearth Support For Standard Surround (Cont’d)

Base Plate Only Installation

Parts Needed: (1) cast ring (2) base zero clearance panel extensions. Discard balance of parts.

Tools Needed: Phillips head screwdriver

1.Attach base zero clearance panel extensions to cast ring.

2.Place assembly under appliance.

Cast Trim Footer

Panel Leg

Panel Extension

Figure 34.1

G. Surround & Trim Set, Econo

(CASTILE INSERT)

Included in Surround & Trim Kit: (2) corner brackets and set screws; (1) trim set, 3 piece; (2) side surrounds; (1) top surround; (4) screws;

Back of Top Panel
	Screws
	Back of Side Panel
Figure	34.2

View of "L" Bracket

installed

Figure 34.3

Tools Needed: Powered Phillips head screw driver

1.Secure the top surround to the surround sides with the screws provided. Figure 34.2.

2.Assemble the trim with the (2) corner brackets provided. Figure 34.3.

3.Slide the assembled trim over the assembled surround set.

4.Remove the cast sides before attaching the surround and trim. Lift up the top to expose the thumb screws at the top of cast side. Figure 34.4.

5.Remove the thumb screw and top bracket and then remove the cast side. Lay it down on a soft surface to avoid scratching the cast.

6.Slide surround and trim over the top of the insert into place. Surround attachs to insert at the top and bottom of insert side. Figure 34.4.

7.Re-install the cast sides and secure with the thumb screws.

Thumb

Screw

Bracket

Surround Set

attaches to top

and bottom of

insert sides.

Figure 34.4

October 27, 2011 7069-101B Page 31