Castile & Santa Fe CE Insert
F. Hearth Support For Standard Surround Only
R
Figure 33.1 - Assembled View
8
7
6
5 
4
1
2 3
Figure 32.2
Item | Description |
1Front, 76mm
2 Front, 127mm
3 Cast Ring, Top & Bottom, Interchangeable
4Side, 127mm
5Side,76mm
6Panel Extension, 127mm
7Panel Extension, 76mm
8 Panel Extension, Base Plate Only
1.Remove contents from box and lay on protective surface to avoid scratching the paint.
2. Lay hearth support’s front and sides face down. Bend the tab down toward the inside.
3.The side pieces are shipped flat. It is much easier to manually flex the sides into a bowed position before installing.
4.Lay 1 cast ring face up, which will become the bottom ring when installed. Attach the 2 sides FIRST and then the front piece.
Figure 33.3.
5. Now turn the cast ring right side up and attach the top cast ring . Figure 33.4.
6. Attach the hearth support’s panel extensions. Figure 33.5
7.Attach cast footers. Figure 33.6.
8. Place the assembled hearth support under the insert. Figure 33.7.
| Sides | |
| InstallFirst | |
Install Front Last | NOTE: Manually | |
| ||
| installing |
Bend top and bottom tabs toward inside
Figure 33.3
Turn right side up and attach top cast ring
Figure 33.4
Alignment
Hole
Panel Extension
Figure 33.5
Cast Trim Footer
Figure 33.6
Panel Leg
Figure 33.7
Page 30 | October 27, 2011 | |
|
|