R
Castile & Santa Fe CE Insert
I. Panel and Trim Set
(SANTA FE INSERT)
1.Lay panel top and legs face down on protective cov- ering to prevent scratching.
1.Attach the panel legs to the top panel using a Phillips head screwdriver. There are 2 screws for each leg.
Figure 36.2.
2.Open the hopper lid by pulling toward you. This will make it easier to set the panels in place. Secure the panels to the insert, 2 screws per leg, as shown in
Figure 36.3.
3.Connect the trim pieces together using the “L” Brack- ets supplied. Figure 36.4.
4.Slide the trim over the top of the panels.
5.Install the access panels. At the bottom of the access panel there are 2 hooks that slip into a slot at the bottom of the side panel and a magnet at the top that holds the access panel in place. Figure 36.3.
Attach panel |
legs to top |
Figure 36.2
Open Hopper Lid for Easier Placement of Panel Set
Magnet
Access Panels
Hook
Figure 36.3
View of "L" Bracket
installed
Figure 36.1- Completed View
Figure 36.4
October 27, 2011 | Page 33 |