Samsung RF263BEAESP/ML manual Completing the SET UP, Refrigerator

Refrigerator
	Compression nut
Plastic tubing	(6.35 mm) (Supplied)
(Supplied)
	Compression fi tting
	(Supplied)
Ferrule	Bulb
(Not supplied)
	Compression nut
	(6.35 mm)
	(Not supplied)
Copper tubing or Plastic tubing
(Not supplied)	(Not supplied)

Household water line

1.Slip the compression nut through the supplied plastic tubing .

2.Tighten the compression nut onto the 6.35 mm compression fi tting.

-If you are using copper tubing, slip the compression nut (not included) and ferrule (not included) on copper tubing (not included) as shown.

-If you are using plastic tubing , insert the molded end (Bulb) of the plastic tubing into the compression fi tting.

Do not use without the molded end(Bulb) of the plastic tubing .

3.Tighten the compression nut onto the compression fi tting. Do not over-tighten the compression nut .

4.Turn water on and check for any leakage.

Only connect the water line to a drinkable CAUTION water source. If you have to repair or

disassemble the water line, cut off 6.35 mm of the plastic tubing to make sure you get a snug, leak-free connection.

14_ setting up

COMPLETING THE SET UP

Now that you have your new refrigerator installed in place, you are ready to set up and enjoy the features and functions of the appliance.

By completing the following steps, your refrigerator should be fully operational.

1.Make sure your refrigerator is in an appropriate location with reasonable clearance between it and the wall. Refer to installation instructions in this manual.

2.Once the refrigerator is plugged in, make sure the interior light comes on when you open the doors.

3.Set the Temperature control to the coldest temperature and wait for an hour. The freezer will get slightly chilled and the motor will run smoothly. Reset the refrigerator and freezer to the temperatures you want.

4.After you plug the refrigerator in, it will take a few hours to reach the appropriate temperature. You can store food and drinks in the refrigerator after the temperature is suffi ciently cool.

DA68-02615D(0.0).indb 14 2012.7.11 8:16:29 PM