Samsung RF260BEAEWW/ML manual Removing the Refrigerator Doors, Required Tools Not provided

REMOVING THE REFRIGERATOR DOORS

For some installations you need to remove the fridge and freezer drawers so you can move the refrigerator to its fi nal location. Do not remove the doors/drawer if you don’t need to. If you do not need to remove the refrigerator doors, go to Adjusting the Level on page 12. If you need to remove the doors. continue below.

Before removing the door/drawer, make sure you read the following items:

Required Tools (Not provided)

You need the following tools to complete the installation of your refrigerator:

Philips	Flat-blade screw	Socket wrench
screwdriver(+)	driver(-)	(10 mm)
Pliers	Allen wrench
	(5 mm)

Disassemble the refrigerator doors

Be careful not to drop and scratch the WARNING doors while removing the doors.

With the door opened

1.Remove 3 screws holding down the TOP TABLE ( 1 ) and turn it with wires connected.

1

2.Disconnect two connector ( 2 ) on the left side door. To remove the water coupler from the hinge, twist and pull it from the hinge.

2

Disconnect power to the refrigerator before WARNING removing the door or drawer.

• Be careful not to drop, damage or

scratch the door/drawer while removing

them.

• Be careful not to get injured while removing the

3.Pull and remove the hinge lever ( 3 ). Remove the ground screw ( 4 ) attached to the upper left door hinges with a philips screwdriver (+). Remove the upper left and right door hinges ( 5 ).

door/drawer.

• Reattach the door/drawer properly to avoid:

3

4

-Moisture from air leakage.

-Uneven door alignment.

-Wasting energy due to improper door seal.

10_ setting up

5

4.Lift the door straight up to remove.

DA68-02616B(0.0).indb 10 2012.6.15 7:47:27 PM