1.Locate the
Unscrew the four Phillips screws 2 slightly to loosen the door.
1 | 2 |
2.Loosen the controller screw 3 with a Phillips screwdriver.
3
3. Find the best level to align the door slope.
Example) The slope is about 2mm (0.08inch) as shown below.
Slope 
Reference 
plane 
-Rotate the Height Adjuster to
After adjustment, fi rst tighten screw 3 and then screw 2 .
CHECKING THE WATER LINE
A water dispenser is one of the helpful features on your new Samsung Refrigerator. To help promote better health, the Samsung water fi lter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms. You may need to purchase a water purifying system to do
10_ Setting up
that. In order for the
Under normal conditions, a 170 cc (5.75 oz.) cup can be fi lled in 10 seconds. If the Refrigerator is installed in an area with low water pressure (below 138Kpa), you can install a booster pump to compensate for the low pressure.
Make sure the water storage tank inside the Refrigerator is properly fi lled. To do this, press the water dispenser lever until the water runs from the water outlet.
Water line installation kits are available at extra cost from your dealer.
We recommend using a water supply kit that contains copper tubing.
Check the accessory list below.
Water fi lter | Hex wrench | Fastener |
Compression | Compression nut |
|
fi tting |
| |
|
|
Connecting to the water supply line
1.First, shut off the main water supply line and turn the
2.Locate the nearest cold water drinking line.
3.After connecting the water supply with water fi lter, turn on water supply and Flush 3L through fi lter before use (fl ush approximately 6 minutes).
1 Cold water line
2 Pipe clamp
3 Water line installation kit
4 Shut off valve
INSTALLING THE WATER LINE
Connecting the water line to the Refrigerator.
There are several items that you need to purchase to complete this connection. You may fi nd these items sold as a kit at your local hardware store.
2012.4.26 3:6:25 PM |