USING THE CONTROL PANEL
Basic temperature of Freezer and Refrigerator Compartments
The basic temperature and/or recommended temperature of Freezer and Refrigerator Compartments are
Controlling the Freezer temperature
The Freezer temperature can be set between
the Freezer button repeatedly until the desired temperature is shown in the temperature display. Keep in mind that foods like ice cream may melt at
Controlling the Refrigerator temperature
The Refrigerator temperature can be set between 7ºC and 1ºC to suit your particular needs. Press the Fridge button repeatedly until the desired temperature is shown in the temperature display.
The temperature control process for the Fridge works just like the Freezer process.
Press the Fridge button to set your desired temperature. After a few seconds, the Fridge will begin adjusting towards the newly set temperature. This will be refl ected in the digital display.
- The temperature of the Freezer, Refrigerator or pantry room may rise when you open the doors too frequently, or if a large amount of warm
or hot food is placed inside.
-This may cause the digital display to blink. Once the Freezer and Refrigerator temperature return to their normal set temperatures, the blinking will stop.
-If the blinking continues, you may need to “reset” the Refrigerator. Try unplugging the appliance, wait for around 10 minutes and then plug the power cord back in.
-The temperature of the pantry room may be a little different according to the location inside.
-If communication between display and Main Controller errors, Pantry display light may blink. Once the pantry room return to their normal set temperatures, the blinking will stop. If the blinking continues for a long period of time, please contact to Samsung Electronics Service Center.
USING THE COLD WATER DISPENSER
Press the Ice / Water button to select the type of you want.
No ICE
Select this if you want to turn
•Place a glass underneath the ice dispenser and push gently against the dispenser lever with your glass. Make sure the glass is in line with the dispenser to prevent the ice from bouncing out.
•Please wait 2 seconds before removing the glass under the dispenser to prevent spills. If the Refrigerator door opens, the dispenser does not work.
•When Cubed Ice is selected after using the Crushed Ice feature, a small amount of residual crushed ice might be produced.
•Water Dispenser Installation
After installation, press the dispenser arm for at least 2 minutes to remove trapped air from the water line and to fi ll the water system.
PUSH
•In case ice doesn’t come out, pull out the ice bucket and press test button located on the right side of
•Do not press the test button continuously when the tray is fi lled with ice or water as illustration. Water may overfl ow or ice jamming may occur.
•Normal Use
To fi ll ice bucket to maximum capacity after installation, make sure to do the following steps.
1.Allow your refrigerator to operate and cool down for 24 hours (or 1 full day).
2.Waiting 24 hours will allow your ice maker to cool properly.
3.Dispense 4 to 6 ice cubes into the glass.
4.After 8 and 16 hours, dispense a full glass of ice at each time.
Operating _13
02 OPERATING
2012.4.26 3:6:30 PM |