Lucent Technologies 117A4 installation instructions From Control Carrier

Model 117A4 Carrier Installation Instructions Installing Multiple Carriers

6Insert the free end of the expansion cable into the IN jack of the expansion carrier immediately to the right of the control carrier.

Note: Although installing an expansion cable into the wrong IN or OUT jack will not harm either carrier, doing so causes all handsets to work improperly and the OUT OF SYNC LED to light.

CAUTION
	ONLY
USE
	CABLE
AT&T
P⁄N	847667896
		IN
		OUT
	OF	SYNC
OUT
	CONTROL/
EXPANSION

From

Control

Carrier

7If you have a second expansion carrier:

a Connect an expansion cable to the OUT jack of expansion carrier #1.

b Insert the free end of the expansion cable into the IN jack of expansion carrier #2.

If you have a third expansion carrier, see the cabling illustration on page 34 for a four-carrier setup.

8Plug an AC adapter cord into the left side of each carrier.

1 2 3 4 5

26 Issue 2 February 1999 Model 117A4 Carrier Installation Instructions 503-801-180