Lucent Technologies 117A4 installation instructions Installing a Single Carrier on a Wall

Installing a Single Carrier Model 117A4 Carrier Installation Instructions

Installing a Single Carrier on a Wall

•Install high on wall, leaving 6–12 inches (15.2–30.5 cm) between antennas and ceiling

•Never install or remove a radio module from a carrier that is plugged into a wall outlet (hot insertion)

1Be sure you have determined the optimal placement for your carrier using the Performance/Range test and the positioning guidelines described in “Positioning Your Carrier(s).”

2Check to make sure the carrier’s power cord is unplugged from the wall outlet before continuing.

3Place the carrier against the wall. Choose a location backed by a wooden stud (if unavailable, use toggle bolts instead of the supplied wood screws). Hold the carrier straight; use a level if needed. Using a nail or pencil, mark screw locations through the four wall-mount holes.

Start the screws, leaving the screw heads protruding approximately ½" (12 mm) from the wall. Place the carrier assembly over the screws, then slide it downward to lock it into place. Tighten the screws.

TRANSTALK

CAUTION

IN

OUT

OFSYNC

OUTCONTROL/

EXPANSION

1 2 3 4 5 6

Model 117A4 Carrier Installation Instructions 503-801-180 Issue 2 February 1999 17