Lucent Technologies 117A4 installation instructions Installing the Remaining Radio Modules

Model 117A4 Carrier Installation Instructions Installing Multiple Carriers

5The PASS and POWER LEDs on all radio modules should be lit and green. If a radio module’s PASS LED is not lit:

a Power down the carriers.

b Unplug from the wall outlet the power cord/AC adapter of the radio module that did not light.

c Wait 15 seconds.

d Plug in the radio module’s power cord again.

e Repower the carriers again, following the proper left-to-right order.

POWER

RADIO

PASS

Radio

Module

POWER

RADIO

PASS

6If your LEDs match the pattern in the illustration in Step 2, you can feel confident that the carriers are cabled correctly and that the installed radio modules are all functional.

7Now go on to "Installing the Remaining Radio Modules" (page 36).

Installing the Remaining Radio Modules

1Power down the carriers.

2Remove the plastic cap covering each radio module’s card edge before inserting the radio modules into the carriers.

36 Issue 2 February 1999 Model 117A4 Carrier Installation Instructions 503-801-180