Procom MN100TBA, MN100HBA, MN060HBA installation manual Instructions, Procedure, GAS to Appliance

OPERATING YOUR HEATER

Manual Control Models

nLIGHTINGn

INSTRUCTIONS

1.STOP! Read the safety information on the side of

heater.

2.Check that gas supply to heater is on.

3.Push in gas control knob

slightly and turn clockwise to the OFF position.

4.Wait five (5) minutes to clear out any air. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety information on the side of the heater. If you do not smell gas, go to the next step.

5.Push in gas control knob

slightly and turn

counterclockwise to “PILOT/IGN” and depress for five(5) seconds

•Set control knob to desired heating position.

NOTE: Both HIGH and LOW are locked positions. You must press in control knob before turning it from these positions.

Figure 16 -1- Control Knob In The OFF Position (MN060HBA)

nTO TURN OFFn

GAS TO APPLIANCE

Shutting Off Heater

1.Turn control knob clockwise

to the OFF position.

2.Turn off all electric power to the appliance if service is to be performed.

Shutting Off Burner Only (Pilot Stays Lit)

Turn control knob clockwise to the PILOT/IGN position.

nMANUAL LIGHTINGn

PROCEDURE

1.	Remove lower front panel(see
	Figure 7 page 7).
2.	Follow steps 1 through 5
	under Lighting Instructions.
3.	With control knob pressed in,
	strike match. Hold match to
	pilot until pilot lights.
4.	Keep control knob pressed in
	for 30 seconds after lighting

NOTE: The first time that the heater is operated after connecting the gas supply , the control knob should be depressed for about thirty (30) seconds. This will allow air to bleed from the gas system.

6.With control knob pressed in, push down and release the ignitor button. This will light pilot. If needed, keep pressing ignitor button until pilot lights.

7.Keep control knob depressed for ten (10) seconds after lighting pilot. If pilot goes out, repeat steps 5,6 and 7.

8.To select the desired heating level, partially press down the control knob slightly and rotate

counterclockwise . Release the downward pressure on the knob while continuing to turn until the knob locks at the desired setting position. Do not operate between locked positions.

Figure 16-2 - Control Knob in The OFF Position (MN100HBA&MN100TBA)

Figure 17 - Pilot

CAUTION: Do not try to adjust heating levels by using the equipment shutoff valve.

pilot. After 30 seconds, release

control knob. Follow step 8

under Lighting Instructions.

5. Replace lower front panel.

1 1