Monessen Hearth C2803VF, C2804VF, C2802VF, C2801VF Important Safety Information, Installer, Owner

Page 3
IMPORTANT SAFETY INFORMATION

IMPORTANT SAFETY INFORMATION

INSTALLER

Please leave these instructions with the owner.

OWNER

Please retain these instructions for future reference.

IMPORTANT

Read these instructions carefully before installing or trying to operate this vent-free gas heater.

WARNING

Any change to this heater or its controls can be dangerous.

Improper installation or use of the heater can cause serious injury or death from fire, burns, explosion or carbon monoxide poisoning.

Do not allow fans to blow directly into the stove. Avoid any drafts that alter burner flame patterns.

Do not use a blower insert, heat exchanger insert or other accessory, not approved for use with this heater where applicable.

1.Due to high temperatures, the appliance should be located out of traffic and away from furniture and draperies.

2.Children and adults should be alerted to the hazard of high surface temperature and should stay away to avoid burns or clothing ignition.

3.Young children should be carefully supervised when they are in the same room with the apli- ance.

4.Do not place clothing or other flammable material on or near the appliance.

5.Any safety screen or guard removed for servicing an appliance, must be replaced prior to operating the heater.

6.Installation and repair should be done by a qualified service person.

7.To prevent malfunction and/or sooting, an unvented gas heater should be cleaned before use and at least annually by a professional service person. More frequent cleaning may be required due to exces- sive lint from carpeting, bedding material, etc. It is imperative that control compartments, burners and circulating air passageways be kept clean.

8.CARBON MONOXIDE POISONING: Early signs of carbon monoxide poisoning are similar to the flu with headaches, dizziness and/or nausea. If you have these signs, obtain fresh air immediately. Have the heater serviced as it may not be operating properly.

9.The installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas

Code, ANSI Z223.l/NFPA54.

10.This unit complies with ANSI Z21.11.2-2001 Unvented Heaters.

11.Do not install heater in a bathroom or bedroom.

12.Correct installation of the ceramic fiber logs, proper location of the heater, and annual cleaning are neces- sary to avoid potential problems with sooting. Sooting, resulting from improper installation or operation, can settle on surfaces outside the fireplace. See log placement instructions for proper installation.

13.Avoid any drafts that alter burner flame patterns. Do not allow fans to blow directly into fireplace. Do not place a blower inside burn area of firebox. Ceiling fans may create drafts that alter burner flame patterns. Sooting and improper burning will occur.

14.Caution: Candles, incense, oil lamps, etc. produce combustion byproducts including soot. Vent-free appli- ances will not filter or clean soot produced by these types of products. In addition, the smoke and/or aromatics (scents) may be reburnt in the vent-free appliance which can produce odors. It is recommended to minimize the use of candles, incense, etc. while the vent-free appliance is in operation.

Continued on page 4

45D0080

3

Image 3
Contents Do not try to light any appliance MODELS C2801VF, C2802VF C2803VF, and C2804VFNatural Gas or Propane/LPG Milli-VoltControl WHAT TO DO IF YOU SMELL GASCONTENTS IMPORTANT SAFETY INFORMATION INSTALLEROWNER Continued from page IMPORTANT SAFETY INFORMATIONInstruction Thermostat Plates Sensor Hi/Lo Knob PRODUCT FEATURESOn/Off Switch Data andOptional Optional Remote Receiver Off/Pilot/On KnobWHAT YOU WILL NEED FOR INSTALLATION GETTING STARTEDMAKE SURE YOU HAVE RECEIVED ALL PARTS IGNITION CONTROLS PRODUCT SPECIFICATIONSNATURAL GAS PROPANE / LPGCODES GENERAL INSTALLATION INFORMATIONDo not install the heater … •In high traffic areas •In windy or drafty areasBTU/Hr = L1 GENERAL INSTALLATION INFORMATIONFront View Corner InstallationWall Installation CLEARANCES / HEIGHT REQUIRMENTSFigure 4 - Gas Connection CONNECTING THE GASexplosion Connecting directly to an unregulatedCONNECTING REMOTE RECEIVER propane/L.P.G. tank can cause anMillivolt ELECTRICAL WIRING MILLI-VOLTFigure 7 - Wiring Diagram CONNECTING OPTIONAL WALL SWITCH OR THERMOSTATELECTRICAL WIRING MILLI-VOLT Figure 8 - Removing Face Plate from StoveScrews Plastic Clip OPERATION OF THERMOSTAT SENSORELECTRICAL WIRING MILLI-VOLT Figure 10 - Clipping Thermo Bulb intoa few hours to vent the odor LOG PLACEMENTDO NOT sprinkle volcanic rocks on the logs or around the pilot. This may cause sootingCHECKING PILOT FLAME FLAME APPEARANCECHECKING BURNER FLAME OPERATING INSTRUCTIONSFOR YOUR SAFETY READ BEFORE LIGHTING OPERATING INSTRUCTIONSWHAT TO DO IF YOU SMELL GAS MILLI-VOLTCONTROL LIGHTING INSTRUCTIONS TO TURN OFF GAS TO HEATEROPERATING INSTRUCTIONS OPERATING INSTRUCTIONS AND CLEANING AND SERVICING CLEANING AND SERVICINGMATCH LIGHTING INSTRUCTIONS REPLACEMENT PARTS LIST LOGSDescription REPLACEMENT PARTS BURNER ASSEMBLY45D0080 C2801/02/03/04VF REPLACEMENT PARTS LISTBURNER ASSEMBLY AccessoriesREMEDY TROUBLESHOOTINGOBSERVED PROBLEM POSSIBLE CAUSEREMEDY TROUBLESHOOTINGOBSERVED PROBLEM POSSIBLE CAUSE45D0080 45D0080 BASIC WARRANTY LIMITED LIFETIME WARRANTY POLICYLIFETIME WARRANTY FIVE YEAR WARRANTY