Napoleon Fireplaces BGNV40-N, BGNV40-P manual LOG Placement, Locating Pins Pilot

LOG PLACEMENT

PHAZERTM logs, glowing and charcoal embers, exclusive to Napoleon fireplaces, provide a unique and realistic glow- ing effect that is different in every installation. Take the time to carefully position the embers for a maximum glowing effect. Figures 27 A - H.

A	LOCATING PINS	#1	LOCATING PINS
	PILOT

15

E

#3

5.When pieces #3a and #3b are attached to create log #3, the upper end of log #3 should rest in the groove, on top of log # 2.

F

1. Looking at the unit from the valve side, place log #1 diagonally across the textured burner cover onto the pins. The texture is designed to cradle the underside of the log.

B #2

#4

6.As with log # 1, log #4 is also cradled by the texture of the burner cover and the pin in the base. Position log #4 so that the lower end fits onto the pin. The upper end rests against the moulded locater on the top of log # 1.

2.Depending on the type of installation, the view of the log positioning will reverse. Here the lower end of log #2 rests near the back left corner of the firebox on the locating pin. The upper end sits on top of log #1, inside the groove on log #2.

G	#5
b
	a

7. Like log #3, log #5

also comes in two

pieces. The base

(#5a) slopes out-

wards between logs

#2 and #4.

As with pieces #3a &

b, piece #5b fits over

piece #5a. Place the

end of piece #5b onto

the pin.

C

D

#3a

#3

b

a

3.Log # 3 is made up of two pieces, a and b. Piece #3a is the base of log #3. The base sits diagonally in the designated area lo- cated between logs #1 and fits tight up against #2.

4.The slot in the under- side of piece #3b fits over #3a. Place the end of piece #3b onto the pin.

H #2

#5

#3 #1 #4

8.The upper end of log #5 rests in the groove, on top of log #4 and creates the final appearance of log set.

W415-0320 / D / 01.06.07