Texas Instruments TMS320DM357 DVEVM v2.05 manual Setting Up the Hardware

Page 14

Setting Up the Hardware

2.1Setting Up the Hardware

To set up the hardware provided with the DVEVM kit, use the steps that follow. You may skip steps if you do not need to access a particular peripheral. For example, if you do not need to use the serial cable, skip that step.

For reference, the numbers in the following photo of the DM357 EVM target board correspond to the steps in the procedure.

8

1

3

4

2

6

5

7

 

 

 

 

 

 

Important: The EVM board is sensitive to static discharges. Use a grounding strap or other device to prevent damaging the board. Be sure to connect communication cables before applying power to any equipment.

2-2

Page 13 Page 15
Image 14
Page 13 Page 15
Contents TMS320DM357 Dvevm Getting Started Guide Important Notice Evaluation BOARD/KIT Important Notice FCC Warning Preface About This GuideTrademarks Contents Contents Dvevm Overview What’s in this Kit? What’s on the Board? DM357What’s Next? EVM Hardware Setup Setting Up the Hardware Audio In P3 Audio Out P5 Composite Video Out J8 Uart P6 Connecting to a Console Window Running the Demonstration Software Default Boot Configuration Starting the Standalone DemosStarting the Standalone Demos Starting the Standalone Demos Running the Standalone Demos Shutting Down the Demos About the Encode + Decode Demo About the Encode DemoIR Remote Buttons for Encode Demo About the Decode Demo IR Remote Buttons for Decode DemoRunning the Demos from the Command Line Running the Network Demo Page Dvevm Software Setup Software Overview Command Prompts in This Guide Application Software ComponentsPreparing to Install Installing the Software Installing the Target Linux SoftwareInstalling the Dvsdk Software Installing the A/V Demo Files Exporting a Shared File System for Target AccessSwitch user to root on the host Linux workstation Testing the Shared File System EVM # setenv nfshost ip address of nfs hostInstalling the Software Setting Up the Build/Development Environment Writing a Simple Program and Running it on the EVMCompile the kernel using the following command Building a New Linux KernelRebuilding the Dvevm Software for the Target Building with DSPLink Booting the New Linux Kernel EVM # setenv serverip tftp server ip addressUsing the Digital Video Test Bench Dvtb Page Additional Procedures Changing the Video Input/Output Methods NtscPutting Demo Applications in the Third-Party Menu File filename.tar.gz Setting Up a Tftp Server You should see the following outputAlternate Boot Methods Booting from Flash Using Board’s Nand Flash File SystemBooting via Tftp Using Board’s Nand Flash File System Booting from Flash Using NFS File SystemBooting via Tftp Using NFS File System Updating/Restoring the Bootloaders Updating U-Boot Using U-BootTo assign a dynamic address, use the following Updating/Restoring the Bootloaders Restoring the Nand Flash Updating the KernelRestoring the Nand Flash Using NFS Restoring the Nand Flash Using RAM Disk and a 2 GB SD Card EVM # tar xf /mnt/mmc/dm357flashimage####.tar EVM # cd Page Index NFSIndex--2 Index--3 Spectrum Digital, Inc 511458-0001B
Top Page Image Contents