Texas Instruments TMS320DM357 DVEVM v2.05 manual What’s in this Kit?

Page 10

What’s in this Kit?

1.1What’s in this Kit?

Your TMS230DM357 DVEVM kit contains the following hardware items. Section 2.1, Setting Up the Hardware tells how to connect these components.

❏EVM Board This board contains a DaVinci TMS320DM357 Digital Media System-on-Chip.

❏Universal Power Supply. Both U.S. and European power are supported.

❏Cables. Serial and Ethernet cables are included to allow for host development.

❏IR Remote Control (Phillips). This universal remote control is included to provide a user interface to the demo applications.

The DVEVM kit also comes with the following software disks. Information about how to use the software components is provided in Chapter 4.

❏DaVinci Digital Software Developer’s Kit, including TI DaVinci Demonstration Version of MontaVista Linux Pro v5.0. (2 DVDs)

❏Spectrum Digital EVM Tools

1-2

Image 10

Contents TMS320DM357 Dvevm Getting Started Guide Important Notice Evaluation BOARD/KIT Important Notice FCC Warning Preface About This GuideTrademarks Contents Contents Dvevm Overview What’s in this Kit? What’s on the Board? DM357What’s Next? EVM Hardware Setup Setting Up the Hardware Audio In P3 Audio Out P5 Composite Video Out J8 Uart P6 Connecting to a Console Window Running the Demonstration Software Default Boot Configuration Starting the Standalone DemosStarting the Standalone Demos Starting the Standalone Demos Running the Standalone Demos Shutting Down the Demos About the Encode + Decode Demo About the Encode DemoIR Remote Buttons for Encode Demo About the Decode Demo IR Remote Buttons for Decode DemoRunning the Demos from the Command Line Running the Network Demo Page Dvevm Software Setup Software Overview Command Prompts in This Guide Application Software ComponentsPreparing to Install Installing the Software Installing the Target Linux SoftwareInstalling the Dvsdk Software Installing the A/V Demo Files Exporting a Shared File System for Target AccessSwitch user to root on the host Linux workstation Testing the Shared File System EVM # setenv nfshost ip address of nfs hostInstalling the Software Setting Up the Build/Development Environment Writing a Simple Program and Running it on the EVMCompile the kernel using the following command Building a New Linux KernelRebuilding the Dvevm Software for the Target Building with DSPLink Booting the New Linux Kernel EVM # setenv serverip tftp server ip addressUsing the Digital Video Test Bench Dvtb Page Additional Procedures Changing the Video Input/Output Methods NtscPutting Demo Applications in the Third-Party Menu File filename.tar.gz Setting Up a Tftp Server You should see the following outputAlternate Boot Methods Booting from Flash Using Board’s Nand Flash File SystemBooting via Tftp Using Board’s Nand Flash File System Booting from Flash Using NFS File SystemBooting via Tftp Using NFS File System Updating/Restoring the Bootloaders Updating U-Boot Using U-BootTo assign a dynamic address, use the following Updating/Restoring the Bootloaders Restoring the Nand Flash Updating the KernelRestoring the Nand Flash Using NFS Restoring the Nand Flash Using RAM Disk and a 2 GB SD Card EVM # tar xf /mnt/mmc/dm357flashimage####.tar EVM # cd Page Index NFSIndex--2 Index--3 Spectrum Digital, Inc 511458-0001B