49
Fault Code E5 - Lid Fault
1.Check for any obstructions within the tub, especially around the flange area where the lid seals.
2.Check customer has not used tall utensils that may have caused the lid to jam.
3.Check the lid system for any physical damage or disconnection of yoke , clip or wiring.
4.Check wiring harness connections at the component and at the controller for any signs of water damage, corrosion or arcing. Replace if damaged.
5.Check the resistance of each lid actuator at the controller, only replace an actuator if it is open or short circuit.
6.Chassis harness P205 pin pair 6 & 7, 8 & 9. Run the lid actuators in diagnostics ( refer p30 & 31) to ensure they move the lid in both upwards and downwards directions. This can be down with the tub removed or pulled slightly forward on the rails.
7.If the fault still occurs, check the sub code fault and, if problem persists, replace the controller.
Fault Code E5 - Sub Code 01 - Not Starting
Lid Actuator
Harness
Lid Clips
Yoke Clip
1.Check harness connection at controller for signs of water damage, corrosion or arcing. Replace if damaged.
2.Check actuator resistance (open or short circuit), if OK then replace controller.
Fault Code E5 - Sub Code 02 - No Current
1.Check harness connection at controller for signs of water damage, corrosion or arcing. Replace if damaged.
2.Check actuator resistance, if open circuit, replace lid actuator.
3.If actuator OK, then replace controller.
Fault Code E5 - Sub Code 04 - Not Stalling
1.Check harness connection at controller for signs of water damage, corrosion or arcing. Replace if damaged.
2.Replace the controller.
