Retaining

59

9.4 Toe Kick Removal

1.Partially open the bottom drawer.

2.Loosen the right and left hand toe kick screws.

3.Slide the toe kick towards the front of the tub until it

comes off the mounting rails.

4. Refit in reverse manner.

Retaining

Screw

9.5 Lower Tub Cowling

1. Remove the lower drawer front (refer section 9.2)

2. Remove the toe kick (refer section 9.4)

3. Release the centre clip as shown and slide the cowling forward.

4. Refit in reverse manner.

Clip

Cowling

9.6 Tub Removal

1.Open the drawer.

2.Removing the drawer front (refer section 9.2) makes it easier to slide the tub rails back (optional).

3.Top tub : depress the right hand tub clip and push it back about 30mm. Repeat for the left hand side.

4.Bottom tub: remove the toe kick (refer section 9.4) and lower tub cowling (refer section 9.5), both optional.

5.If the cowling has not been removed, then the tub clips need to be pushed back about 130mm so the slide clears the cowling when the tub is lifted.

6. Lift the tub off the slides and push the runners back into the product.

7.Releasing the wire from the centre clip on the link assembly allows the tub to be moved further from the chassis (optional).

8.If the tub is being turned over for servicing, rotate it counter clockwise, remembering to remove the baskets first. Removing the handle will prevent it from being damaged.

9.Refit in reverse manner.

Rail Clip

Page 59
Image 59
Fisher & Paykel DD247, DD607 service manual Retaining Screw, Clip Cowling, Rail Clip