61
9.9Detergent Dispenser
1.Remove the drawer front (refert section 9.2)
2.Disconnect the two wiring lock connections from the dispenser coils.
NOTE: Push back the locking tabs to allow the connectors to release.
3.With a small bladed screwdriver, carefully release the small plastic clips holding the rinse aid indication LED in place and remove the LED.
4.Use pliers to release the clamp and remove the fill hose from the dispenser.
5.While holding the dispenser, unscrew the six torx drive screws securing the two brackets to the dispenser.
6.The dispenser can not be removed from inside the tub.
7.To open the dispenser door fully, first open the door using the release catch, then squeeze the top sides of the door together. This will release the door to the fully open position. This can be done with the dispenser in place.
8.Refit in the reverse manner ensuring the dispenser gasket is located correctly.
Harness Lock
Torx Screws
Fill Hose
Coils
Rinse Aid LED
Torx Screws
9.10Electronic Controller
1.Remove the drawer front (refer section 9.2) and optionally the handle can be removed for ease of servicing. (refer section 9.3).
2.Disconnect the wiring connectors to the controller.
3.Use a flat blade screwdriver to release the clip on the righ hand side of the controller by firmly pushing it towards the tub. Do not lever against the clip, as there is a chance of breaking it.
4.The bottom of the controller can now be lifted out to an angle of 45o, at which point the top of the controller will come free from the tub.
5.Refit in reverse manner, ensuring the controller is located correctly in behind the tub flange at the top.
NOTE: When servicing a single integrated wireless product, it is importanat to only fit a spare part controller as a replacement, as the product will detect the wireless receiver and set the correct wash profile.
Do not fit a controller that has previously been installed in Clip an other product.
