74
Place of the remote for binding
iii)Once the remote is in roughly the location shown above, press one of the buttons on the remote. The left transmit LED icon should flash followed by five fast flashes of the right hand battery icon. This indicates that remote has paired with the receiver. The LEDs are labelled below.
Transmit LED indicator
Top Tub start button on doubles.
Single tub start button on singles
Battery Level
LED indicator
Bottom tub start button on doubles. (Not on singles)
iv)Remove the remote from the wash programme selector. Now press a button on the remote. This should flash the ‘transmit’ LED once and cause the relevant tub to ‘beep’.
v)If the above is successful it means the remote is paired to the receiver. If either the remote or receiver is replaced then the procedure must be repeated.
