Fisher & Paykel DD607, DD247 service manual Hex Drive Screws Rail Rear Locating Tabs, Water Valve

68

9.22 Slide Rail Replacement.

1.Remove the tub, refer section 9.6

2.Remove the required lid actuator from the slide rail being replaced, refer section 9.21.

3.Remove the appropriate chassis trim (refer section 9.27) to gain access to the screws of the rail being replaced.

4.Remove the 2 hex drive screws securing the rail to the chassis.

5.Tap the slide rails from underneath at the front to free from it’s location in the chassis.

6.Pull forward to release the rear locating tabs.

7.Refit in reverse order, take care that the chassis is square before tightening the screws.

Hex Drive Screws

Rail Rear Locating Tabs

9.23 Mains Filter Cover and PCB Mains Filter

1.Remove the lower tub, refer section 9.6

2.Release the clips on the mains filter cover and lift it off.

3.Disconnect all wiring to the PCB mains filter.

4.Remove the earth screw through the wire and the mains filter housing to the chassis.

5.Use a screwdriver to release the clips holding the circuit board inside the housing and lift it out.

6.Refit in reverse manner.

Water Valve

Clips

Inlet Hose

Flood Sensor

MFB