63
9.13 Water Softener (if fitted)
1.Remove the drawer front (refer Section 9.2).
2.Disconnect the wiring loom connections to the water softener diverter valve, brine pump and salt level detector, and remove the dispenser wiring loom connection to the electronic controller.
3.Use a flat blade screwdriver to open the salt level indicator LED cover, and remove the LED from the water softener.
4.Unclip the fill hose to strainer and remove the dispenser hose from the water softener.
5.Remove the four T10 torx drive screws securing the water softener to the tub. The water softener can now be removed from the product.
6.To refit, place the overflow ‘O’ ring on the water softener and lubricate the tub overflow with a
7.Place the salt tank ‘O’ ring in the tub. Lubricate the salt
tank flange on the water softener. Pass the dispenser wiring loom through the water softener and plug it into the electronic controller.
8.Place the water softener in the tub and apply enough pressure to seat the ‘O’ rings.
9. The overflow should sit almost flush with the inside of the tub. The salt tank should be recessed by approx 1mm (1/32 inch) from the inside of the tub
10.Refit the screws, strainer, hoses, harness connectors and LED.
9.14Strainer (if fitted)
1.Remove the water softener hose from the detergent dispenser spigot.
2.Place screwdriver under clip and use lever action to disengage the clip.
3.When clip is disengaged, the strainer can be pushed
down off the water softener spigot.
4.After removing the hose clamp, the strainer can now be removed from the DishDrawer.
5.Fit new strainer & position hose clamp. Manoeuvre strainer into place.
6.Slide into spigot using a force applied in an upwards movement. Lock into place, and ensure correct fitting.
7.Fit dispenser hose to detergent dispenser spigot.
ByPass Valve
Strainer
Water Softener
Salt Sense
Brine Pump
Strainer
Spigot
