Stardance Natural Vent Gas Heater
Optional Accessories Available
Fan Kits
FK26 Fan
The FK26 fan kit helps distribute heated air from within the firebox out into the room. The fan is controlled by a snapstat that turns power on and off as the firebox tem- perature rises above and falls below a preset tempera- ture. A rheostat provides for variable fan speeds.
Specifications
115 Volt / 60Hz / .75 amps
Maintenance
The fan itself does not require regular maintenance, however, periodic cleaning of the fan and the surround- ing area is required.
Installation
Refer to Page 8 for installation instructions.
Remote Controls
The remote control allows you to turn the heater on or off from anywhere in the room. Refer to Page 21 for wiring diagrams.
Model | Functions Controlled |
RC1 | ON/OFF |
RC2 | ON/OFF and Temperature |
IMTFK | Wall mounted thermostat control |
Clockwise to Open |
Counterclockwise |
to Close |
Handle Holder |
ST621/624 |
Fig. 44 To open doors, insert handle and turn. Store handle in handle holder.
2.With the doors open, hold the screen at an angle with the bottom hanger toward the inside. (Fig. 45)
3.Place the hangers on the bottom rib of the front cast iron frame.
4.Push the top of the screen toward the stove to allow the spring on the screen to catch at the top of the stove front.
5.Remove the screen by grasping the handle (only when cool) and pulling towards you. Then lift to dis- engage the hangers.
Screen Kit
The S30SK screen kit is designed for use on the Star- dance Gas Stove with operable doors.
Installation Precautions
Be sure the stove is cool before beginning installation.
WARNING: DO NOT REMOVE GLASS.
Never close the doors with the screen in place. Do- ing so could cause damage to either the screen or the doors.
Never handle the screen while the stove is in operation or when the stove and screen
are hot. Installation Instructions
To install the screen on the cast front, the operable doors must be completely open. The doors must remain in the open position whenever the screen is used.
1.Open the front doors by inserting the handle into the door latch stub and turn clockwise. (Fig. 42) When not in use, the handle may be stored in the handle holder located on the right side of the rear shroud. (Fig. 44)
Glass
Spring
Screen 
Bottom
Hangers
KT230
Fig. 45 Hold screen at an angle to attach bottom hangers.
20007067 | 25 |