Vermont Casting 2310 operating instructions Draft Problems, Safety Tips

The Maintenance Guidelines given below will help you develop a schedule that works for you. Once you have developed a maintenance schedule, stick to it.

Daily:

•Ashes should be removed before the ashes reach the top of the ashpan. Check at least once a day. A build up of ashes under the grates will not only restrict the supply of air going to the fire, but may contribute to overheating the grates, causing them to warp.

Two Weeks:

•Inspect the stove interior air ports and passageways; look for fly ash or coal that might block either incom- ing or outgoing gases.

•Inspect chimney connector and chimney. Clean if necessary.

Two Months:

•Check handles and latches to be sure that they are working properly. If gasketing becomes compressed over time, adjust the latch.

•Brush out fly ash or soot that may have been depos- ited in the chimney connector, particularly in horizon- tal runs or in elbows.

Yearly Spring Cleaning:

•Check the grates and gasketing for wear; replace gasketing if necessary.

•Inspect the stove interior air ports and passageways; look for fly ash or coal that might block either incom- ing or outgoing gases.

•Remove ashes and place a desiccant in the ashpan to absorb moisture from the air.

•Clean dust off the bottom heat shield so it retains its heat-reflective value.

•Tighten the leg bolts and bottom heat shield assem- bly.

•Paint the stove when necessary.

•Thoroughly brush the chimney and connector to remove all fly ash.

•Inspect the chimney and chimney connector for any signs of deterioration. Have a professional mason repair the chimney. Replace chimney connector sections if any appear to be corroded.

•Is the door handle adjusted so the doors close tight- ly? Instructions for adjusting the handle are given in the Maintenance Section.

Vermont Castings Vigilant

Draft Problems

If the draft in the chimney is interrupted, smoke, which contains carbon monoxide and other toxic gases, may be forced out of the stove and chimney and into liv- ing areas. This is a potentially hazardous condition. If you notice a sulfur-like smell or if smoke backs out of the stove frequently, let the fire go out. Be sure all air inlets are clear, the chimney connector and chimney are clean, and your stove is being operated correctly before starting another fire.

The following suggestions may help solve draft related problems:

•When your heating needs are light and you are oper- ating your stove to produce a small amount of heat, in Spring or Fall for instance, run your stove with the damper open to direct heat to the flue and maintain good draft. Small, hot fires, with the damper open, work well in Spring and Fall.

•Operating your stove with the damper open will help keep flue temperatures high. When outside temperatures rise to 50°F., you may begin to notice draft problems which were not present when outside temperatures were colder. In this situation it is rec- ommended to refrain from burning coal.

•If you notice draft problems when the wind is blow- ing, install a chimney cap designed to stabilize draft under windy conditions.

Safety Tips

Keep all safety equipment ready for use.

•Test the smoke alarm to be sure it is operating prop- erly.

•Be sure the fire extinguisher works and is clearly vis- ible. All occupants of the house should know where it is, and how it operates.

•Have heavy stove gloves available near the stove.

•Have special safety accessories (e.g., Child Guard Screen) available for use if small children will be in the home.

2000898 23