Vanguard Managed Solutions PRVYS18PWA installation manual Operating Heater, Lighting Instructions

Page 15

OWNER’S MANUAL

OPERATING

HEATER

MANUALLY CONTROLLED MODELS

FOR YOUR SAFETY

READ BEFORE

LIGHTING

WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result caus- ing property damage, personal injury or loss of life.

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

•If you cannot reach your gas sup- plier, call the fire department.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service technician or gas supplier. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been un- der water.

Ignitor Button

LIGHTING

INSTRUCTIONS

WARNING:

•If fireplace has glass doors, never operate this heater with glass doors closed. If you op- erate heater with doors closed, heat buildup inside fireplace will cause glass to burst. Also if fireplace opening has vents at the bottom, you must open the vents before operating heater.

•You must operate this heater with a fireplace screen in place. Make sure fireplace screen is closed before running heater.

NOTICE: During initial operation of new heater, burning logs will give off a paper-burning smell. Open damper or window to vent smell. This will only last a few hours.

Note: Homeowners generally prefer to operate their heater with the chimney damper closed. This will put all the heat into the room. However there may be times you will desire the full flames of the High heat setting but will find the heat output excessive. You can open the chim- ney damper (if you have one) fully or partially to release some of the heat.

WARNING: Damper handle will be hot if heater has been running.

1.STOP! Read the safety information above.

2.Make sure manual shutoff valve is fully open.

3.Press in and turn control knob clock-

wise

Clockwise

to the OFF position.

Control Knob

4.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety in- formation in column 1. If you don’t smell gas, go to the next step.

5.Slightly depress and turn control

knob counterclockwise C-clockwiseto the PILOT position. Keep control knob pressed in for five (5) seconds (see Figure 22).

Note: You may be running this heater for the first time after hook- ing up to gas supply. If so, the con- trol knob may need to be pressed in for 30 seconds. This will allow air to bleed from the gas system.

•If control knob does not pop out when released, contact a qualified service person or gas supplier for repairs.

6.With control knob pressed in, press and release ignitor button. This will light pilot. The pilot is attached to the burner. If needed, keep pressing ig- nitor button until pilot lights.

Note: If pilot does not light, contact a qualified service person or gas sup- plier for repairs. Until repairs are made, light pilot with match. To light pilot with match, see Manual Light- ing Procedure on page 16.

7.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob.

Note: If pilot goes out, repeat steps 3 through 7.

8.Slightly depress and turn control

knob counterclockwise C-clockwiseto the HIGH position. The burner should light. Set control knob to any heat level between HIGH and LO.

Ignitor

Thermocouple

 

Electrode

Pilot Burner

HIPILOT

OFF

LO

Figure 22 - Control Knob and Ignitor Button Location

Figure 23 - Pilot

(Note: Appearance of pilot assembly may vary by model.)

Continued

104343

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Patent Pending What to do if YOU Smell GASOak Log Design Log DesignVanguard FLAME-MAX Unvented PROPANE/LP GAS LOG Heater Safety InformationUnpacking Product FeaturesProduct Identification Local CodesConfined and Unconfined Space AIR for Combustion and VentilationProviding Adequate Ventilation Unusually Tight ConstructionAIR for Combustion Ventilation Determining Fresh AIR Flow for Heater LocationDetermining if You Have a Confined or Unconfined Space Ventilation Air From Outdoors Ventilation AIRVentilation Air From Inside BuildingInstallation InstallationCheck GAS Type If Not Using Mantel If Using MantelMinimum Non-combustible Material Clearances Determining Minimum Mantel Clearance Determining Minimum Mantel Clear- ance When using a HoodMantel Clearances Floor ClearancesInstalling Damper Clamp Accessory for Vented Operation Installing Heater Base AssemblyChimney Minimum Permanent Height ft Flue Opening sq. ins Installation Items Needed Standard Oak Log ChassisGolden Oak and Birch Model Chassis Accessories, Connecting to GAS SupplyTest Pressures Equal To or Less Than 1/2 Psig Pressure Testing Heater Gas ConnectionsPressure Testing Gas Supply Piping System Checking GAS ConnectionsInstalling Logs For Vintage Oak ModelFor Golden Oak or Birch Models Lighting Instructions Operating HeaterShutting Off Heater Manual Lighting ProcedureVariable Control Operation To Turn OFF GAS To ApplianceMain Burner Inspecting BurnersThermostat Control Operation Pilot Flame PatternObserved Problem Possible Cause Remedy TroubleshootingMaintenance, Gas leak. See Warning statement at TopFor Masonry and FACTORY-BUILT Metal Fireplace Optional Positioning of Thermostat Sensing BulbSpecifications Logs Cleaning and MaintenanceReplacement Parts ODS/PILOT and BurnerIllustrated Parts Breakdown FLAME-MAX Vintage OAK Models VYS18P and VYS24PODS Pilot VYS18P VYS24P Parts List1117 612 VYD18P, VYBD18P VYD24P, VYBD24P VYD30P, VYBD30P VYD36P Thermostatically Controlled Models VYD18PT VYD24PT VYD30PT VYD18PT VYD24PT VYD30PT VYD18PT VYD24PT VYD30PTManual Shutoff AccessoriesService Hints Technical Service104343 Warranty Information

PRVYS18PWA specifications

Vanguard Managed Solutions PRVYS18PWA is a cutting-edge technology platform designed to revolutionize the way individuals and businesses manage their financial investments. This innovative solution combines advanced tools and features to provide a comprehensive approach to asset management.

One of the standout features of PRVYS18PWA is its intuitive user interface, which makes navigating and using the platform a seamless experience for users of all skill levels. The dashboard provides real-time insights and analytics, enabling users to track their investments’ performance easily. Powerful reporting tools are integrated, offering detailed summaries and projections that help users make educated financial decisions.

PRVYS18PWA utilizes state-of-the-art algorithms and machine learning technologies to analyze market data and trends. This feature allows users to receive personalized investment recommendations tailored to their financial goals and risk tolerance. AI-driven tools continuously learn from user interactions, ensuring that the advice provided remains relevant and up-to-date.

Security is a top priority for Vanguard Managed Solutions, and PRVYS18PWA is no exception. The platform incorporates advanced encryption protocols and two-factor authentication to protect sensitive data, ensuring that user information and financial assets are secure at all times. Users can feel confident in their transactions and the integrity of their personal information.

Another impressive characteristic of PRVYS18PWA is its integration capabilities. The platform can seamlessly connect with various financial institutions and other investment tools, allowing users to consolidate all their financial data in one place. This integration streamlines the management process and provides a holistic view of an individual’s or organization’s finances.

For those keen on sustainability, PRVYS18PWA offers various eco-conscious investment options. The platform allows users to explore socially responsible investment opportunities, aligning with personal values and promoting a positive impact on society and the environment.

Furthermore, PRVYS18PWA includes robust educational resources, ensuring users have access to the knowledge needed to make informed investments. From industry insights to market analyses and investment strategies, users can enhance their financial literacy and make more confident decisions.

Overall, Vanguard Managed Solutions PRVYS18PWA is an exceptional investment management tool that combines user-friendly design, advanced technologies, and educational resources to empower users on their financial journeys. Whether a novice investor or a seasoned professional, PRVYS18PWA offers features and functionalities to meet diverse needs and promote financial growth.
Top Page Image Contents