Vanguard Heating VP1600ITA, VP2200ITA Models VP1600D and VP2600D, Operating Heater, Continued

Page 22
Models VP1600D and VP2600D

22

OPERATING HEATER

Models VP1600D and VP2600D

Continued

4.Wait five minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety information at the top of page 21. If you don’t smell gas, go to the next step.

5.Press in control knob.

Note: You may be running this heater for the first time after hooking up to gas supply. If so, you may need to press in control knob for 30 seconds. This will allow air to bleed from the gas system.

If control knob does not pop up when released, contact a qualified service person or gas supplier for repairs.

6.With control knob pressed in, push down and release ignitor button. This will light pilot. The pilot is attached to the front of burner. If needed, keep pressing ignitor button until pilot lights.

If pilot does not light

turn control knob clockwise ClockwiseManual background to the OFF position

repeat steps 5 and 6

If pilot does not stay lit after several tries

refer to Troubleshooting, pages 26 through 29

contact a qualified service person or gas supplier for repairs

Until repairs are made, light pilot with match. To light pilot with match, see Manual Lighting Procedure, page 24 .

Ignitor Electrode

Pilot Burner

Thermocouple

Figure 21 - Pilot

7.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob.

Note: If pilot goes out, repeat steps 3 through 7.

101823

Image 22
Contents OWNER’S OPERATION AND INSTALLATION MANUAL INFRARED VENT-FREEPROPANE/LP GAS HEATERINFORMATION CONTENTSSAFETY WARNINGSWARNINGS Continued SAFETY INFORMATIONContinued IDENTIFICATION FEATURESPRODUCT LOCAL CODESVENTILATION FRESH AIRCOMBUSTION Section 5.3, Air for Combustion and VentilationContinued FRESH AIR FOR COMBUSTION AND VENTILATIONDETERMINING FRESH-AIRFLOW FOR HEATER LOCATION VENTILATION AIR FRESH AIR FOR COMBUSTION AND VENTILATIONContinued Ventilation Air From Inside BuildingVentilated Outlet Attic Air FRESH AIR FOR COMBUSTION AND VENTILATIONContinued OutletTO WALL INSTALLINGContinued Continued INSTALLING TO WALLTHERMOSTAT SENSING BULB TO WALL INSTALLINGINSTALLING HEATER TO WALL ContinuedMarking Screw Locations INSTALLING TO WALLContinued Attaching Mounting Bracket To WallContinued INSTALLING TO WALLInstalling Bottom Mounting Screws Placing Heater On Mounting BracketTO GAS CONNECTINGSUPPLY TO GAS CHECKINGCONNECTIONS SUPPLYTO GAS CONNECTINGPRESSURE TESTING HEATER GAS CONNECTIONS SUPPLYOPERATING HEATER FOR YOUR SAFETY READ BEFORE LIGHTINGModels VP1600ITA and VP2200ITA Models VP1600ITA and VP2200ITA OPERATING HEATERLIGHTING INSTRUCTIONS ContinuedModels VP1600ITA and VP2200ITA HEATEROPERATING TO SELECT HEATING LEVELTHERMOSTAT OPERATION MANUAL LIGHTING PROCEDURETO TURN OFF GAS TO APPLIANCE OPERATING HEATERModels VP1600D OPERATINGand VP2600D FOR YOUR SAFETY READ BEFORE LIGHTINGOPERATING HEATER Models VP1600D and VP2600DContinued Models VP1600D and VP2600D OPERATING HEATERTO SELECT HEATING LEVEL ContinuedOPERATING HEATER INSPECTING BURNERMANUAL LIGHTING PROCEDURE TO TURN OFF GAS TO APPLIANCEContinued INSPECTING BURNERBURNER FLAME PATTERN TROUBLE CLEANINGMAINTENANCE SHOOTINGTROUBLE Cleaning and MainteCleaning and Mainte SHOOTINGsee Cleaning and TROUBLE- SHOOTINGsee Cleaning and see Cleaning andTROUBLE SERVICETECHNICAL SHOOTINGSERVICE PUBLICATIONS SERVICE HINTS SPECIFICATIONSPARTS REPLACEMENTACCESSORIES Parts Under WarrantyModel VP1600ITA ILLUSTRATEDBREAKDOWN PARTSPART PARTS LISTModel VP1600ITA NUMBERPARTS Model VP2200ITAILLUSTRATED BREAKDOWNModel VP2200ITA PARTS LIST098304-01 PARTS Model VP1600DILLUSTRATED BREAKDOWNModel VP1600D PARTS LIST098304-01 PARTS Model VP2600DILLUSTRATED BREAKDOWNModel VP2600D PARTS LIST098304-01 LIMITED WARRANTY WARRANTY INFORMATIONVANGUARD VENT-FREEPROPANE/LP GAS HEATERS